Electrolux EHG60412 Installation, Disposal of the appliance, Important safety requirements

Models: EHG60412

1 16
Download 16 pages 35.43 Kb
Page 4
Image 4
Disposal of the appliance

4electrolux

with applicable cable. Speak to your local Service Force Centre.

The appliance must have the electrical in- stallation which lets you disconnect the appliance from the mains at all poles with a contact opening width of minimum 3 mm.

If the fixing bracket is near to the terminal block, always make sure the connection cable does not come in contact with the edge of the bracket.

You must have correct isolation devices: line protecting cut-outs, fuses (screw type fuses removed from the holder), ground leakage trips and contactors.

Disposal of the appliance

To prevent the risk of physical injury or damage

Disconnect the appliance from the power supply.

Cut off the mains cable where it con- nects with the appliance and discard it.

Flat the external gas pipes if there are fitted.

Speak to your local authorised facilities for disposal of your appliance.

INSTALLATION

Warning! The following instructions about installation, connection and maintenance must be carried out by qualified personnel in compliance with standards and local regulations in force.

Important safety requirements

This hob must be installed in accordance with the Gas Safety (Installation and Use) Regulations (Current Edition) and the IEE Wiring Regulations (Current Edition).

For appliances installed in the Republic of Ireland please refer to NSAI- Domestic Gas Installation I.S. 813 Current Editions and the ETCI Rules for Electrical Installations.

Provision for ventilation

Detailed recommendations are contained in the following British Standards Codes Of Practice: B.S. 6172/ B.S. 5440, Par. 2 and B.S. 6891 Current Editions.

The hob should not be installed in a bed sit- ting room with a volume of less than 20 m³. If it is installed in a room of volume less than 5 m³ an air vent of effective area of 100 cm² is required. If it is installed in a room of vol- ume between 5 m³ and 10 m³ an air vent of effective area of 50 cm² is required, while if the volume exceeds 11 m³ no air vent is re- quired.

However, if the room has a door which opens directly to the outside no air vent is required even if the volume is between 5 m³ and 11 m³.

If there are other fuel burning appliances in the same room, B.S. 5440 Part 2 Current

Edition, should be consulted to determine the requisite air vent requirements.

For appliances installed in the Republic of Ireland please refer to the NSAI- Domestic Gas Installation I.S. 813 Current Editions Table Four.

Location

The hob may be located in a kitchen, a kitchen/diner or bed sitting room (with a volume greater than 20 m³), but not in a bathroom or shower room.

The minimum distance combustible materi- al can be fitted above the hob in line with the edges of the hob is 400 mm. If it is fit- ted below 400 mm a space of 50 mm must be allowed from the edges of the hob.

For appliances installed in the Republic of Ireland please refer to NSAI- Domestic Gas Installation I.S 813 Current Edition Section 7- Permitted Locations of Appliance.

Gas Connection

Warning! Any gas installation must be carried out by a GAS SAFE REGISTER installer.

Make sure that, once the hob is installed, it is easily accessible for the engineer in the event of a breakdown.

The manufacturer will not accept liability, should the above instructions or any of the other safety instructions incorporated in this instruction booklet be ignored.

On the end of the shaft, which includes the G 1/2" threaded elbow, adjustment is fixed so that the washer is fitted between the

Page 4
Image 4
Electrolux EHG60412 Installation, Disposal of the appliance, Important safety requirements, Provision for ventilation