10
Install Remote Blower Motor System
NOTE: The blower motor housing can be mounted
using 4 holes from either the inlet side or the outlet side
of the blower.
Position the remote blower motor housing in its
mounting location and mark the 4 mounting hole
locations.
Drill 4 mounting pilot holes using a ³⁄16” (5 mm) drill bit.
Attach the remote blower motor housing to the
mounting location with four 6 x 80 mm mounting
screws and washers.
If Blower Motor is removed, reinstall the blower
motor assembly and secure it with the screws
1.
2.
3.
4.
Remote Blower Motor
Installation into Hood Insert
Prepare for Mounting the Remote Blower System
The remote blower system must be fastened to a se-
cure structure of the roof, ceiling, wall, oor, or new or
existing frame construction. The 4 holes on either the
inlet (bottom) side or the outlet (top) side of the blower
must be used to mount the remote blower system to
the structure.
NOTE: The mounting hole locations must span the
studs. Additional stud framing may be required.
Plywood may be used to span open areas between
ceiling joists or roof rafters to aid installation. This
structure must be strong enough to support the weight
of the remote blower system (50 lb [22.6 kg] min).
Prepare the Remote Blower System
Excessive Weight Hazard
Use two or more people to move and install
Remote blower motor system.
Failure to do so can result in back or other injury.
Using two or more people, move the remote
blower motor system to the mounting location.
Remove the 10 screws from the front cover of the
remote blower motor housing and set them aside.
Remove the front cover of the remote blower
motor housing and set it aside.
NOTE: To make the blower motor housing easier to
mount, the blower motor assembly can be removed. If
you do not want to remove the blower motor assem-
bly, proceed to “Install Remote Blower System” in this
section.
To Remove Blower Motor
Disconnect the motor electrical plug from the
blower motor assembly.
Remove the screws that secure the blower motor
assembly to the remote blower housing and set
them aside.
Pull the spring clip to release the blower motor
assembly. Remove the blower motor assembly
from the housing and place it on a covered
surface.
1.
2.
3.
1.
2.
3.
A
BC
D
A. Front cover
B. Blower mounting bolts (4)
C. Spring clip
D. Motor electrical plug
A
AA
A
A. Mounting holes
A
A
Blower Motor Systems Installation
Inlet Side
Outlet Side