Electrolux EI30HI55KS, EI36HI55KS, EI48HI55KS

joints. Use furnace duct tape to seal all joints

tightly.

Make Electrical Connections for Remote Blower

Motor System

Electrical Shock Hazard

Disconnect power before servicing.

Replace all parts and panels before operating.

Failure to do so can result in death or electrical

shock.

Electrical Connection Inside Remote Blower System

Disconnect power.

Connect the wires from the wiring conduit to the

wires from the motor electrical plug cable inside

the remote blower housing terminal box.

E. Red wires

F. Blue wires

G. Gray wires

H. Green (or yellow/green) and

green/yellow wires

I.Motor electrical plug cable

A.UL listed or CSA approved

1⁄2” (1.3 cm) wiring conduit

B.UL listed wire connectors

C.Black wires

D.White wires

previously removed. If it is removed, reattach the

motor electrical plug to the connector on the

blower motor assembly.

Complete Preparation

Determine and make all necessary cuts for the

vent system.

IMPORTANT: When cutting or drilling into the ceiling

or wall, do not damage electrical wiring or other hid-

den utilities.

Determine the location where the ½” (1.3 cm)

wiring conduit will be routed through the ceiling or

wall between the remote blower and the hood insert.

Drill a 1¹⁄4” (3.2 cm) hole at this location.

Locate the electrical terminal boxes in the remote

blower housing and hood insert (see “Complete

Preparation” in the “Prepare Location” section).

Remove the terminal box covers and set the

covers and screws aside.

Remove the electrical knockout from the remote

blower housing and hood insert (see “Preparation”

in the “Prepare Location” section) to prepare for

the installation of the UL listed or CSA approved

½” (1.3 cm) wiring conduit and conduit connector.

NOTE: Strain relief conduit are supplied with

remote blower hardware.

With the hood insert mounted (see the “Install Hood

Insert” section), run the ½” (1.3 cm) wiring conduit

between the remote blower motor housing and the

hood insert. Pull enough ½” (1.3 cm) wiring conduit

to allow for easy connection to the terminal boxes

in the remote blower housing and hood insert.

Run the six 18 AWG wires through the 1⁄2” (1.3

cm) wiring conduit and conduit connectors and

into the terminal boxes on the remote blower

housing and hood insert. Leave enough wire length

in each terminal box to make the wiring connections.

Install the conduit connectors and conduit to the

remote blower housing and hood insert electrical

terminal boxes.

NOTE: Strain relief conduit are supplied with

remote blower hardware.

Connect the vent system to the hood insert and

remote blower motor system. Use clamps at all

A. Electrical terminal box

B. Electrical knockout

Blower Motor Systems Installation

A. Vent System

B. Remote Blower Motor

C. Ceiling

D. Roof rafters / Plywood

E. Remote Blower Wiring

Conduit

F. Hood Insert Wiring

Conduit

G. Hood Insert