CARE OF STAYCLEAN SURFACES
Stayclean surfaces destroy splashes of food and fats when the oven temperature is raised to around 220°C.
To aid this process it is a good idea to run the Top oven for an hour or two per week without food. to ensure continued good performance from the Stayclean finish. Use the Oven Clean function for the main oven. See page 31.
HINTS AND TIPS
Manual cleaning of Stayclean is not recommended. Damage will occur if oven sprays or abrasives of any kind are used.
Slight discolouration and polishing of the Stayclean surface may occur in time. This does not affect the Stayclean properties in any way.
A good time to allow the oven to run on is after the weekly roast. After removing the roast, turn the oven up to 220°C and allow to run for an hour or so. It is important not to allow a
Follow the recommendations below to keep oven soilage to a minimum.
Cook at the recommended temperatures. Higher temperatures during roasting will increase soilage. Try cooking at lower temperatures for an increased length of time, you will save energy and often the joint is more tender.
Use minimal, if any, extra oil or fat when roasting meat; potatoes only require brushing with fat before cooking. Extra fat in the oven during roasting will increase splashing and soilage.
It is not necessary to add water to a meat tin when roasting. The water and the fat juices from the joint create excessive splattering during cooking even at normal temperatures as well as causing
lcondensation.
Covering joints during cooking will also prevent splashing onto the interior surfaces; removing the covering for the last
REPLACING AN OVEN LIGHT BULB
The type of bulb required is a 300°C. 25 watt small Edison Screw. Part number 572 491
CAUTION: DISCONNECT THE APPLIANCE FROM THE ELECTRICITY SUPPLY BEFORE REPLACING THE BULB.
Open the oven door and remove the shelves to enable easy access to the oven light assembly.
Insert a flat blade screwdriver between the oven side and the glass which covers the bulb. Support the glass with your hand and prise out sufficiently to release the glass cover. Unscrew the bulb in an anticlockwise direction until it is possible to remove the bulb with ease.
Fit the new bulb by turning in a clockwise direction until it is secure. Ensuring the indent to the flange is pointing to the rear of the oven, replace the glass by pushing it firmly into the hole to cover the bulb assembly.
Replace the shelves. Restore the electricity supply and adjust the time of day as necessary.
37
