Electrolux ES510 To Remove and Replace the Warming Drawer some models, To Remove Warming Drawer

Setting Oven Controls

(Removing & Replacing Warming Drawer)

Electrical Shock Hazard can occur and result in serious injury or death. Disconnect appliance from electric power before cleaning and servicing the warmer drawer.

To Remove and Replace the Warming Drawer (some models)

To Remove Warming Drawer:

	1.	Turn power OFF before removing the Warming Drawer.
	2.	Open the drawer to the fully opened position.
	3.	On the right glide you will find a shield attached with a hex-head screw
		(See Fig. 1). Use a 1/4” socket and ratchet to remove the shield.
	4.	Locate glide lever on each side of drawer, pull up on the left glide lever and
		push down on the right glide lever.
	5.	Pull the Warming Drawer away from the range.
Fig. 1	To Replace the Warming Drawer:
	1.	Replace shield on the right glide of the drawer body.
	2.	Pull the bearing glides to the front of the chassis glide (See Fig. 2).
	3.	Align the glide on each side of the drawer with the glide slots on the range.
	4.	Push the drawer into the range until levers “click” (approximately 2”). Pull
		the drawer open again to seat bearing glides into position. If you do not
		hear the levers “click” or the bearing glides do not feel seated
		remove the drawer and repeat steps 2-4. This will minimize possible
		damage to the bearing glides.

Fig. 2

NOTE: The Warming Drawer will NOT operate while in the Self-Clean and “Oven Lockout” modes

30