12 | electrolux | first use |
The water softener must be set in both ways: manually, using the water hardness dial and electronically, using some of the programme buttons on
the control panel
Setting manually
The dishwasher is factory set at position 2.
1.Open the dishwasher door.
2.Remove the lower basket from the dishwasher.
3.Turn the water hardness dial to position 1 or 2 (see table).
4.Replace the lower basket.
Setting electronically
The dishwasher is factory set at level 5.
The electronic setting of the water |
| |
softener is possible | ONLY | with the 3 |
in 1 function deactivated. |
|
|
1.Press the On/Off button. The dishwasher must be in setting mode.
2.Press simultaneously and keep pressed buttons 2 and 3, until the lights of buttons 1, 2 and 3 start flashing.
3.Press button 1, the lights of buttons 2 and 3 turn off while the light of the button 1 goes on
flashing, at | the same time the | end | ||
of programme | indicator light |
| ||
starts to flash. |
| |||
The current level is indicated by | end | |||
the number of | flashes of the | |||
of programme | indicator light (see |
| ||
chart). |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
Examples:
5 flashes, pause, 5 flashes, pause, etc... = level 5
6 flashes, pause, 6 flashes, pause, etc... = level 6
4.To change the level, press function button 1. Each time the button is pressed the level changes. (For the selection of the new level see the chart).
Examples:
if the current level is 5, by pressing function button 1 once, level 6 is selected.
if the current level is 10, by pressing function button 1 once, level 1 is selected.
5.To memorise the operation, switch
off the dishwasher by pressing the On/Off button.
