Oven Control Style 2 -
Setting the Clock and Minute Timer
Control Style 2
Q
OVEN
For a silent control panel (Control Style 2 Only):
When choosing a function, a beep will be heard each time a pad is pushed. If desired, the controls can
be programmed for silent operation. Push and hold STOP TIME for 7 seconds. After 7 seconds, the control will beep once. This will block the controls from sounding when a pad is pushed. To return the sound, push and hold STOP TIME again for 7 seconds until 1 beep is heard. Note: The control will return to the audible mode after a power outage.
_LOCK
To Set the Clock Style 2
When the range is first plugged in, or when the power supply to the range has
been interrupted, the display will flash "12:00".
1.Push _.
2. | Within | 5 seconds, | push | and | hold(_ | or_ | until the | correct | time of day | |
| appears | in | the | display. |
|
|
|
|
|
|
| Note: | The | clock | cannot | be | changed | during | any timed | bake | or |
| cycle. |
|
|
|
|
|
|
|
|
|
To Set the Minute Timer Clock Style 2
1.Push _.
2. Push_ | to | increase | the | time | in | one | minute | increments. | Push | and | ||||
hold_ | to | increase | the time | in | 10 | minute | increments. | The |
| timer | can | be | ||
set for any amount of time | from | 1 minute to 11 hours and 59 minutes. | ||||||||||||
Note: | If you | push_ | first, |
| the | timer will | advance to | 11 | hours | and | 59 |
minutes.
3.The display shows the timer count down in minutes until one minute remains. Then the display will count down in seconds.
4.When the set time has run out, the timer will beep 3 times. It will then
continue to beep 3 times every 60 seconds until_ | is pushed. |
Note: The minute timer does not start or stop cooking. It serves as an extra timer in the kitchen that will beep when the set time has run out. The minute timer can be used alone or during any of the other oven functions. When the minute timer is in use with any other mode, the minute timer will be shown in the display. To view other functions, push the function pad for that mode.
To Change the Minute Timer while it is in use: |
|
While the timer is active and shows in the display, push and hold[_ | or_ |
to increase or decrease the time. |
|
To Cancel the Minute Timer before the set time has run out: