Electrolux ESL 66010 user manual Something not working, Possible cause and solution

30 electrolux something not working

Something not working

The dishwasher will not start or stops during operation.

Certain problems are due to the lack of simple maintenance or oversights, which can be solved with the help of the indications described in the chart, without calling out an engineer.

Open the door and carry out the following suggested corrective actions.

	Fault code and malfunction	Possible cause and solution
● continuous flashing of the light of the			● The water tap is blocked or furred with
	running programme,		limescale.
● point-shaped optical signal is flashing,			Clean the water tap.
●	appears in the digital display,		● The water tap is turned off.
			Turn the water tap on.

●intermittent audible signal,

		● The filter (where present) in the threaded
The dishwasher does not fill with water		hose fitting at the water inlet valve is
		blocked.
		Clean the filter in the threaded hose.
		● The water inlet hose has not been
		correctly laid or it is bent or squashed.
		Check the water drain hose connection.
● continuous flashing of the light of the		● The sink spigot is blocked.
	running programme,	Clean out the sink spigot.
● point-shaped optical signal is flashing,		● The water drain hose has not been
●	appears in the digital display,	correctly laid or it is bent or squashed.
		Check the water drain hose connection.

●intermittent audible signal,

The dishwasher will not drain
● continuous flashing of the light of the	● Close the water tap and contact your
running programme,	local Service Force Centre.

●point-shaped optical signal is flashing,

● appears in the digital display,

●intermittent audible signal,

Anti-flood device is activated

Remember to switch off the appliance before carrying out any corrective action.