8
3.Press function button 1.
The LED indicator for function button 1 will flash.
The LED indicator for the end of the dishwashing cycle will flash simul-
taneously:
–The number of times that the LED indicator for the end of the dish-
washing cycle flashes corresponds to the hardness setting.
–This sequence of flashes is repeated several times, with a 3 second
pause in-between.
4.Pressing function button 1 increases the hardness setting by 1 degree.
(Exception: hardness setting 1 follows hardness setting 10).
5.When the hardness setting is correct, press the ON/OFF button.
The hardness setting is now saved.
If the water softener is set electronically to “1”, this switches off the
control indicator for dishwasher salt.
Water hardness Adjusting the hardness
setting Number of
flashes
in °d1)
1)(°d) German degree, measure of the hardness of water
in mmol/l2)
2)[mmol/l] millimol per litre, international unit for wa ter hardness
Range Manual Electronic
51 - 70
43 - 50
37 - 42
29 - 36
23 - 28
9,0 - 12,5
7,6 - 8,9
6,5 - 7,5
5,1 - 6,4
4,0 - 5,0
IV 1
103)
9
8
7
6
3)On this setting the length of the dishwashing cycle may be slightly longer.
*) factory setting
10
9
8
7
6
0*
19 - 22
15 - 18
3,3 - 3,9
2,6 - 3,2 III 5
4*
5
4
11 - 14 1,9 - 2,5 II 3 3
4 - 10 0,7 - 1,8 I/II 2 2
below 4 below 0.7 I
1
no salt
necessary
1