Component Teardown
Crisper Cover Assembly Removal
The crisper cover assembly slides into a slot formed in the left and right hand supports that are secured with screws to the liner sidewall.
To remove the crisper cover assembly:
1.Remove crisper drawers from unit.
2.Reach under the crisper cover and lift up on the crisper cover glass insert. Remove glass insert from unit. (See Figure
3.Grab the crisper cover assembly from the front, lift upwards until front of crisper cover clears the front lip of the crisper cover supports then pull straight out.
4.The humidity damper control is separated from the crisper cover by using a flat bladed screwdriver from the inside of the crisper cover, and prying the top retaining latches of the damper control off of the crisper cover. Push the retaining latches through until the damper control is free from the crisper cover.
5.To remove the crisper cover supports, extract the three screws securing each crisper cover support to the liner sidewall.
Light Shield Removal
The light shield is secured with retaining tabs that locate in slots cut in the interior cabinet ceiling.
(See Figure
To remove the light shield, grab the light shield and push in near the retaining tabs until the retaining tabs release from the slots in the compartment ceiling.
Light Fixture Removal
The light fixture is secured with retaining latches into the interior cabinet ceiling behind the light shield.
(See Figure
To remove the light fixture:
1.Remove light bulb by turning
2.Pull down on the front of the light fixture while turning the fixture a quarter turn to release the retaining latches.
3.Disconnect wire leads from light fixture terminals.
Crisper Cover | Crisper Cover |
Support LH | Support RH |
| Screws |
Humidity
Control LH
Glass
Insert
Humidity
Control LH
Crisper Cover
Assembly
Retaining
Latches
Figure 5-13. Light Shield and Fixture Removal
| Light Fixture |
| Light Bulb |
Tab |
|
Light Shield | Tab |
|