Installation Information
Door Removal
For some installations it may be necessary to remove the door to fit through the entrance of the installation site.
To remove the door, follow the steps below.
1.Make sure electrical plug is disconnected from the wall outlet.
2.Gently lay freezer on its back on a soft clean surface.
3.Lift plastic cover off upper hinge assembly. (See Figure
4.Using a 3/8” socket or wrench, extract hex head screws securing the upper hinge to the unit frame.
5.Remove the grille/kickplate by extracting the screws from each end of the grille/kickplate.
(See Figure
6.Using a 3/8” socket or wrench, extract hex head screws securing the lower hinge to the unit frame. Use a phillips head screwdriver to extract the remaining screw from the lower hinge assembly.
7.Lift the door assembly off of the unit frame.
Door Handle Mounting Instructions
For some installations the door handle may need to be removed. (See Figure
To remove the door handle, use a 3/32” allen wrench and extract the setscrew from each end of the handle until handle slides off the handle mounting shoulder screw.
Hinge Cover
Hex Head
Screws
Hinge Plate
Figure 7-4. Top Hinge Removal
Hex Head
Screws
Screw
Screw
Figure 7-5. Bottom Hinge Removal
Handle Mounting
Shoulder Screw
Door Handle
3/32” Allen Wrench