Electrolux K 7 18 40 - 1i Something Not Working, Symptom Possible Cause Remedy

Something Not Working

If the appliance is not functioning correctly, please carry out the following checks before contacting your local AEG Service Force Centre.

Warning!

Repairs should only be carried out by qualified service engineers. Repairs carried out by inexperienced persons may cause injury or serious malfunc- tioning.

Symptom Possible Cause Remedy

	Appliance is not switched on
	Mains plug is not plugged in
Appliance does not work.	or is loose.
	Fuse has blown or is defective.
	Socket is defective.
Appliance cools too much.	Temperature is set too cold.
	Temperature is not properly
	adjusted.
	Door was open for an exten-
	ded period.
The food is too warm.
	A large quantity of warm food
	was placed in the appliance
	within the last 24 hours.
	The appliance is near a heat
	source.

Interior lighting does not work. Light bulb is defective.

Switch on the appliance.

Insert mains plug.

Check fuse, replace if neces- sary.

Electrical malfunctions are to be corrected by an electrician. Turn the temperature control knob to a warmer setting.

Please look in the "Initial Start Up" section.

Only open the door as long as necessary.

Turn the temperature control knob to a colder setting.

Please look in the "Installation location" section.

Please look in the "Changing the Light Bulb" section. Carefully warm the leaking sections of the door seal with a hair dryer (not hotter than

Heavy build up of frost, possi- bly also on the door seal.

The compressor does not start immediately after changing the temperature setting. Water on the floor or on sto- rage shelves.

Door seal is not air tight (pos- sibly after reversing the door).

This is normal, no error has occurred.

Water drain hole is blocked.

approx. 50 °C). At the same time shape the warmed door seal by hand until it sits cor- rectly.

The compressor starts after a period of time.

See the "Cleaning and Care" section.

13