My bed is connected to a T-Max®

 

Troubleshooting

 

 

 

Problem

Solution

 

 

 

My bed is connected to a T-Max®

You have probably attempted to connect your sunbed to the

remote system but I am having

remote system already. Disconnect the remote plug(s) from the

trouble getting into “id” mode

ports at the back of the sunbed, wait 90 seconds and try again.

 

 

 

My bed, connected to a T-Max®

 

 

Manager, did not display “dL” but

 

 

does indicate:

 

 

“0”

1. Remote device has not been set.

 

2. The sunbed has not been connected to the remote system, see

 

Remote Connections.

a tanning time and the lamps

1. Delay time of T-Max® Manager has not been set.

have come on

2. Delay time has expired and session has begun.

a tanning time but the lamps

Auto start function of T-Max® Manager has been turned off.

have not come on

Press the timer button to turn on lamps.

 

 

 

When auto-addressing the first bed

When using the auto address feature of the T-Max® Manager

does not register an “id”

you must wait 10 seconds from the time you start the auto

 

address function before addressing the first bed.

 

 

 

When using a T-Max® 1A my

SunStar® Bypass plugs or terminator plugs may be needed if

sunbed won’t function properly

the T-Max® 1A and the sunbed are over 100 feet apart. Install

 

the plugs in the open remote port in the sunbed and the T-

 

Max® 1A.

 

 

 

My salon suffers frequent, short

If you have a T-Max® Manager, changing parameter 23 from

power outages and clients com-

“0” to “1” will allow the tanning bed to remember how much

plain about losing session time

time was left when power goes out and resume its session

 

after power is restored. Consult your T-Max® Manager manu-

 

al for information on setting parameters.

 

 

 

27964-01A

26

Page 31
Image 31
Philips 27964-01A user manual Troubleshooting, Problem, Solution, My bed is connected to a T-Max, Remote Connections