Philips 27964-01A user manual Operation - Using Your Sunbed, A Bc D E F G

Operation - Using Your Sunbed

Using Your Sunbed

When connected to the T-Max® Manager or T-Max® 1A or 3A.

A BC D E F G

27964-01A

AFace tanner control - Turns face tanners on and off during use. Face tanner lamps require one minute to relight. (Units equipped with face tanner only)

BBody tanner control - Turns body lamps on and off during use. (Units equipped with face tanner only)

CBody fan control - Controls the speed of the body fan during use.

DBody fan speed indicator - Indicates speed of fan. (OFF - LOW - MED - HI)

ETimer display - Displays remaining time.

FStop button - Interrupts tanning session.

GTimer button - Turns bed on. Timer dis- play shows remaining time.

WARNING

Wear protective eyewear.

Failure to may result in severe burns or longterm injury to the eyes.

1.Lift the canopy, lie down on the bench (face up), lower the canopy toward your body using the canopy handle. See Safety Information for positioning instructions.

2.Put on your safety goggles.

3.Assuming the remote system has been set to allow a pre-tanning delay time, the timer display (E) will repeatedly flash the delay symbol “dL” and then the remaining delay time. Press the timer button (G) or wait until the delay time has expired to begin the tanning session. The lamps will turn on and the timer will begin to count down.

4.When the timer reaches 0 the lamps turn off. If you want to stop your session before time expires, press the stop button (F).

5.Raise the canopy by using the outer edge, do not push up on the acrylic shield. The cooling fans run for a period of time after the lamps shut off to aid in cooling the sunbed. The timer will indicate “..” as a reminder to clean the sunbed. After the sunbed is cleaned press the timer button and the display will return to “0”.

18