Care and Maintenance - Lamp and Acrylic Replacement
Removing/Replacing Face Tanner Lamp (if equipped)
After removing the canopy acrylic shield, replace the face tanner lamp as follows:
Note! Never take hold of the lamp such that your fingers are in contact with the lamp glass. Finger oils will greatly reduce the lamp’s operational life.
Step 1 Support the face tanner assembly | Step 3 Gently close the face tanner |
with your hand while unscrew- | glass casing and lock it closed |
ing the two retaining screws. The | with the screws. Ensure that the |
face tanner glass casing will | screws firmly secure the glass |
swing downward. | casing. |
Step 2 The lamp can now be exchanged. The lamp holders are equipped with spring con- tacts which enable the lamp to be removed easily. Remove the old lamp and discard. Install the new lamp, using a clean cloth or paper towel. Ensure that the lamp is firmly seated in the lamp holders.
DANGER
Unfiltered light from face tanner can cause severe burns.
Never turn sunbed on while face tanner is disassembled or when glass filters are removed.
Immediately discontinue use of this equipment if face tanner glass is broken or any unfiltered light can be seen escaping face tanner assembly.
RETAINING
SCREWS
23
