Philips 27964-01A Setting the sunbed address manually, Installation - Remote Connections

	Installation - Remote Connections
Scenario 7 - Non T-Max® Remote System wired	Setting the sunbed address manually
to unit	Before connecting your sunbed to the T-Max®
Most non-T-Max® remote systems control the
sunbed by the use of a relay. The relay operates	Manager or T-Max® 1A or 3A, the address of
the sunbed by connecting and disconnecting a	your sunbed must first be set. Set the “id” man-
pair of wires leading from the sunbed. Refer to the	ually as described below.
user’s manual provided with your remote system	Setting the “id”
to determine if it operates in this way. To connect
your sunbed to this type of system a remote inter-	1. Make sure no cables are plugged into
face kit is required. Contact your place of purchase	your sunbed’s remote ports.
to obtain the kit. The illustration below details a	2. Remove and reapply power to the unit.
typical connection. Follow the instructions provid-
	3. Press and hold the stop button, located
ed with the kit and from the remote’s manual to
	on the sunbed display, for three seconds
make the necessary connections.
	and release. The display should indicate
	an “id” number from “oF” to “252”.

27964-01A

CAUTION

The remote connection is not designed to supply or accept high voltage, nor can it provide power to an external timer. The sunbed’s remote inter- face circuitry operates on 5 volts, attempting to connect it to any higher voltages will damage the sunbed as well as void your warranty.

1-99

100-199

200-252

4.If you are using a T-Max® 1A or 3A as a “master” remote, the “id” of the sunbed must be set to “1”. If you are using a T- Max® Manager each sunbed must be assigned a different “id”. To set the “id” press the timer button, to count up, or the body fan control button, to count down, until the desired number is achieved.

5.Press the stop button to return to the normal display mode.

16