Philips 27964-01A Installation - Remote Connections, Scenario 2 - T-Max 3A with Wireless

Installation - Remote Connections

Scenario 1 - T-Max® Manager Series with Complete Wireless

Connect one AP-900 (with Power

Injector) to the Manager and one AP-900 to each of the tanning beds. Install as many beds as you

like with this configuration. Units that do not communicate with T-Max will need an AP-900 with Power Injector and an additional 3A to operate. If you have an older

T-Max® Manager that doesn’t support auto addressing, set the address of each sunbed manually as described in Setting the address man-

ually. You can place your sunbed at any location in the series.

Scenario 2 - T-Max 3A with Wireless

In single sunbed installations, the T-Max® 1A and 3A can offer the same control as the T-Max® Manager, eliminating the need for a Manager. If you’re using a 1A in this manner, it must have a chip labelled “master” installed on its circuit board. The remote control bypass plug must not be used in this configuration. The 3A may be used as a “master” with no modification.

After you have set the T-Max® 1A’s, or 3A’s, address to “0” (refer to your T-Max® user’s guide) and the sunbed’s address to “1”, simply connect one AP-900 (with Power Injector) to the T-Max® 3A and one AP-900 to the tanning bed.

NOTE: A T-Max® 1A with a

“master” chip can be substituted

for a 3A.

27964-01A

Scenario 3 - T-Max® Manager

Series with Wireless combo

Connect one AP-900 (with Power Injector) to the Manager and one

AP-900 to a wireless ready tanning bed. The rest of the salon may be “daisy- chained” together and connected to the wireless equipped tanning bed, eliminating the need to wire the Manager to the tanning beds.

14