Installation - Pre-Installation Planning 
Pre-Installation Planning
Before you begin to assemble your sunbed, you should observe the following consid- erations.
WARNING
Shock hazard.
Disconnect power before servicing.
•The SUNVISION Elite™ 30 and 32 series require a dedicated circuit capable of providing 30 Amp ser- vice at 220VAC. This unit must be hardwired directly to a junction box. We recommend connection by a professional electrician.
•IMPORTANT! Voltage must be below 230V AC or may require a Buck Booster.
CAUTION
Use of a voltage source above 230V AC may prevent proper operation of the sunbed and could cause damage and void the warranty.
CAUTION
Air from the room is used to cool the sunbed. Maximum ambient room temperature should be 80°F. Place your sunbed no closer than 6” from any wall. Make sure nothing obstructs the airflow into the sunbed’s endcaps or out of the fan openings. A poorly ventilated room may cause the unit to become hot and cause discomfort to the user.
CAUTION
Proper assembly of your sunbed requires three people. Plan to have a couple of helpers assist you.
2
