Manuals / Electrolux / Kitchen Appliance / Freezer

Electrolux K 7 18 40-4i installation instructions Apply covers C-D into the relevant holes

Models: K 7 18 40-4i

1 24

Download 24 pages 26 Kb

Page 21

Image 21

Apply covers (C-D) into the relevant holes.

Snap ventilation grille (B) and hinge cover (E) into position.

D	C
	E
	B

Separate parts Ha,Hb, Hc, Hd as shown in the figure

Place guide (Ha) on the inside part of the furniture door, in the upper and lower positions as shown in the fig- ure and mark the position of external holes. Having drilled the holes, fix the guide with the screws supplied.

Ha		Hb
Hc
	Hd
PR266
ca. 50 mm
	90°
	2
	1 m
		m
	90°
ca. 50 mm	2
	2
	1 m
		m

Page 21

Image 21

Electrolux K 7 18 40-4i Apply covers C-D into the relevant holes, Separate parts Ha,Hb, Hc, Hd as shown in the figure

Contents

SANTO K 7 18 Integrated Fridge Freezer Operating and Installation InstructionsDear customer Safety ContentsService and Spare Parts Guarantee Conditions Regulations, Standards, GuidelinesSafety of children SafetyIntended use Prior to initial start-upDisposal ServiceDaily Operation Appliance Packaging InformationRemove transport packaging Disposal of old AppliancesShelf holders Setting “0” Off Starting up and temperature regulationFor safety, store in this way only one or two days at the most Interior AccessoriesFresh food refrigeration Storage ShelvesFreezing and storing frozen food Defrosting Preparation of Ice CubesRefrigerator FreezerSwitching off the appliance Cleaning and CareIf the appliance is not going to be used for an extended period Energy Saving Tips Symptom Something Not WorkingPossible Cause RemedyChanging the light bulb Service and Spare Parts 0870 5Customer Care Department Guarantee Conditions Guarantee ConditionsEuropean Guarantee Installation Electrical ConnectionWARNING - THIS APPLIANCE MUST BE EARTHED Positioning Housing dimensionsYour appliance needs air Reversing the doorInner door reversal Instructions for building-inApply joint the sealing strip as shown in figure Drill the unit using a ³ 2,5 mm drill 10 mm max. penetration Apply covers C-D into the relevant holes Snap ventilation grille B and hinge cover E into positionSeparate parts Ha,Hb, Hc, Hd as shown in the figure Fix cover Hc on guide Ha until it clips into place Hb HdPR167/1 Regulations, Standards, Guidelines 06/04 2222