Operating Instructions
30
Washing is heavily
creased.
Probably too much washing
has been put inthe drum.
Pay attention to the maximum
load quantity (see Programme
Tables). In the case of easy-
care fabrics, select the EASY
IRON programme.
Washing is not
thoroughly spun,
water remains visi-
ble in the drum.
The END light
flashes twice an
acoustic signal is
emitted twice.
The drain hose is kinked. Remove the kink.
The maximum pump height
(outlet height 1 m from
thebase of the appliance)
isexceeded.
Contact your local Service
Force Centre. For pumping
heights over 1m a co nversion
kit is available as a special ac-
cessory.
The drain pump is blocked.
Switch off the machine and
disconnect the mains plug.
Clean the drain pump.
For siphon attachments:
thesiphon is blocked. Clean the siphon.
The door cannot be
opened when the
washing machine
ison.
START/PAUSE
andDOOR lights
come on.
Door is locked due to high
water level, or high tempera-
ture.
Wait until the programme has
ended, the DOOR light goes off
and the END light is lit.
If it is necessary to open the
door immediately,
Turn the programme selector
to OFF; then turn it to DRAIN.
Press the START/PAUSE but-
ton.
When the water has been
pumped out, the door can be
opened.
Power failure dur-
ing a wash pro-
gramme (all
indicator lights
areoff).
The failure may be caused by
a blown house fuse or by a
mains supply fault into the
house.
(For safety reasons, the door
remains locked for around
2minutes.)
The programme continues
when power is restored.
If washing has to be taken out
during a power cut:
Turn the control knob to OFF.
Carry out emergency emptying
(see Section "Carry out emer-
gency emptying“).
After about 2minutes,
thedoo r can be opened by
pulling on the handle.
Problem Possible ca use Remedy