Electrolux WA GLE S7000 Select the Start/Pause

Incorrect option selection

If an option which is not compatible with

the set wash programme is selected, the

message Err is displayed for about 2

seconds and the yellow Start/Pause light

start flashing.

Alarm codes

In the event of operating problems, some

alarm codes can be displayed, for example

E20 (see paragraph «Something not

working»).

End of programme

When the programme has finished a

flashing zero is displayed, the «Door» pilot

light and the Start/Pause light go out and

the door can be opened.

Select the «Start/Pause»

To start the selected programme, press the Start/Pause button; the corresponding

red pilot light stops flashing.

The washing pilot light «Waschen/Lavage» is on to indicate that the appliance

starts operating.

The door pilot light «Tür/Porte» is on to indicate the door is locked.

To interrupt a programme which is running, depress the Start/Pause button: the

corresponding red pilot light starts to flash.

To restart the programme from the point at which it was interrupted, press the

Start/Pause button again.

If you have chosen a delayed start, the machine will begin the countdown.

If an incorrect option is selected, the yellow pilot light of the Start/Pause button

flashes for 3 times the message Err is displayed for about 2 seconds.

18 Use

132962330_EN.qxd 10/06/2008 14.03 Pagina 18

Contents

Main Page Page Page Contents Page Page Instruction for the user Safety information Prior to using for the first time General safety Installation Use Child Safety Product description Detergent dispenser drawer Control panel First Use 1 2 3 4 5 6 7 8 9 10 Personalization Acoustic signals Child safety lock Daily Use Load the laundry Measure out the detergent and the fabric softener Select the required programme Select the spin speed or the rinse hold option Programme option button Select the Prewash option Select the Stain option Select the Sensitive option Select the Time Saving option Display Duration of the selected programme Delay Incorrect option selection Select the Start/Pause Select the Delay Start Programme progress display Select an additional rinse Altering an option or a running programme Interrupting a programme Cancelling a programme Opening the door after the programme has started At the end of the programme * Stain option can be selected only at the temperature of 40C or higher. ** Washing programmes pprrooggrraammmmee Washing programmes pprrooggrraammmmee Aus/Arrt Programme informations Preparing the wash cycle Sorting out the laundry Temperatures Before loading the laundry Maximum loads Laundry weights Removing stains Detergents and additives Quantity of detergent to be used Degrees of water hardness 30 International wash code symbols 132962330_EN.qxd 10/06/2008 14.03 Pagina 30 International wash code symbols Care and cleaning Descaling After each wash Maintenance wash External cleaning Washing drum Door seal Drain pump Water inlet filter Emergency emptying out Frost precautions Something not working E10 : E20 : E40 : Page Page Techinical Data Consumption value Installation Unpacking A C C B D B Positioning and levelling Water inlet Water-stop device Water drainage Electrical connection Permanent connection Environment concerns Packaging materials Old machine Ecological hints