OPERATING INSTRUCTIONS CHECKLIST
BEFORE OPERATING THIS APPLIANCE, CAREFULLY PROCEED THROUGH THE FOLLOWING CHECKLIST
1.Read and understand these instructions before installing or operating this appliance.
2.This appliance is should be installed and repaired by a fully qualified service person who must be familiar with the instal- lation of the Mantis
3.Installers who are not familiar with the installation of this ap- pliance should contact Empire Comfort Systems, Inc. prior to installing the appliance to avoid creating hazardous operating conditions.
4.Check and inspect the appliance for gas leaks. In the event of gas leaks, cut off the gas supply to the heater immediately and call your gas supplier or installer.
5.Check and verify that all flue venting combustion air intakes and flue outlets are unobstructed.
6.Refer to pages 19 to 21 for Single Flue pipe and pages 30 to 31 for
7.Do not use alternative Flue or cap on installation other than that specified in this manual - otherwise heater will malfunc- tion and cause hazardous operating conditions and will void the manufacturer’s warranty.
8.Check and verify that flue pipe connection to the appliance when using single 1 1/2” flue pipe installation is correctly installed and secured in line with instruction in this manual, Pages 19 to 21.
9.Prior to operating the appliance, check for dust or debris on the burners. Refer to Page 46, Figure 56.
10.Check and verify that logs are place correctly as per instruc- tions on Page 18 of this manual. If logs are incorrectly po- sitioned, it can create a hazardous situation, and in most in- stances, the heater will not operate correctly.
11.Do not light heater without logs installed, as heater will not operate properly.
12.Check and verify prior to starting the appliance, that all panels are secured in place and that the main door has been locked in position.
13.After verifying and checking all the above points, proceed to lighting instructions. Refer to pages 37 to 38.
Page 35 |
