Raven Installation Guide Installation
MAN-RAVIG (Ver. 1.1)
3-3
3.4 Mounting the Raven 3.4.1 Mounting the Heatsink
The Raven dissipates its heat by natural convection, up to loads of 500W. For higher
output loads, the amplifier should be mounted on an additional heatsink or cooled by
fan. There are two 4.5-mm holes in the base plate for mounting an additional heatsink
(see Figure 3-1).
3.4.2 Mounting on the PC Board
When mounting the Raven on a PC board, four screws (in addition to the solder pins)
may be installed to provide a mechanical connection. It is important to provide a spacer if
any components are located above the amplifier. Failure to do so can warp the PC board
or puncture the amplifier case. When selecting screws, the following specifications
should be used. If a spacer has been added, the screw length must be calculated to
penetrate the case by no more than 2.6 mm.
Screw Type: Phillips Pan Head Self-tapping (for plastic) screw – Nickel-plated Steel.
Meets standards ISO 1478, EN 21478, or DIN 7970.
d ST2.2
L 4.5*
P 0.8
dk 4.2
k 1.8
m≈ 2.6
Phillips size 1
*4.5 mm is typical for mounting on a
PC board assembly without spacers.
Table 3-1: Dimensions in Millimeters
Main Diameter Minor Diameter Flat End Diameter
Basic
Diameter ISO
Nr. Pitch
P D1max D
1min D
2max D
2min D
3max D
3min
ST2.2 2 0.8 2.24 2.1 1.63 1.52 1.47 1.37