Elo TouchSystems 1525L manual Command syntax summary Command Syntax Meaning

				Appendix A. Installation and Setup
Command syntax summary
	Command Syntax			Meaning
	mtcfg			list installed MagTek device drivers
	mtcfg -?			display a help page
	mtcfg -help			display a help page
	mtcfg -models			list available MagTek device models
	mtcfg port-name			list settings for a given device
	mtcfg port-name	–allmore		verbose list of settings
	mtcfg port-name model		[settings]	* add and configure a new device
	mtcfg port-name	–delete		* delete a device
	mtcfg port-name	settings		* change settings for a device

*these commands require Administrator privilege. MTCFG will display an error message if the current user is not an Administrator.

Displaying Configuration Information (WNT/2000/XP)

To display the list of configured MagTek devices, use the following syntax:

mtcfg

To display the settings for a single device, use:

mtcfg COMx

COMx is the name (virtual port) of the device, as set when the device was first configured. This name is shown in the leftmost column in the list of devices. This command displays only the common settings for the device−the ones that are most likely to require modification. To display all device settings, including all data parsing format strings, use the following syntax:

mtcfg COMx –all more

The pipe symbol and “more” will present the information one screen at a time.

Adding New Devices (WNT/2000/XP)

To add a new device use the following command syntax:

mtcfg port-name model

or

mtcfg port-name model settings

port-nameis the name (virtual port) chosen for the new device. It must not be used by another device in the system (MagTek or other). The port name in the form COMxxx (valid values are COM5 .. COM255). MTCFG will verify that the name is not used by other MagTek devices that were set up with this utility, but it will not check whether the name is used by any other device in the system.

155