Turning On the DVR5100
Press the power button located on the right front of the DVR5100. The Pelco logo turns blue when power is applied.
During startup, the DVR5100 reads configuration files from the flash card, and then copies them to a protected partition on the hard disk drives. This mirroring of the operating system drive is a critical aspect of the reliability designed into the DVR5100. Once turned on, the two databases are synchronized regularly. If a hard disk drive failure occurs, this synchronization ensures that the system can recover quickly and efficiently by replacing the failed drive. The startup time is extended as a result of the database synchronization.
The DVR5100 front panel control pad contains four
The lights of the control pad cycle through various color combinations during the startup process. Once complete, the blue and red function buttons on top of the control pad are steady. At this point, you can either log on to the unit or change the output monitor configuration.
CHANGING THE MONITOR CONFIGURATION
The default DVR5100 monitor configuration is VGA. You should see the log on prompt if you are using a VGA monitor. If you are using a composite or
•Press Menu 
.
•Press the yellow function button for NTSC or the green function button for PAL. The unit will restart in a composite monitor output mode.
NOTE: Figure 20 shows the monitor selection label that is positioned on the top of the DVR5100.
Figure 20. Monitor Selection Label
LOGGING ON FOR THE FIRST TIME
Each time you start the DVR5100, the system automatically begins a
Figure 21. Autologin Dialog Box
An administrator can enable or disable the autologin feature from the General System setup screen. In addition, an Administrator can select a different user to automatically log on for future access. Once the time counts down to zero, the designated user is logged on. To interrupt the autologin process or log on as a different user, follow the steps below to log on with the keyboard/mouse or the control pad. The default user is “admin.”
•Select the admin user from the user ID list (if not selected).
•Enter the password with the USB keyboard [or the on-screen keyboard].
| 25 |
