Pelco DVR5100 manual Inserting Cage Nuts

3.Attach one front-mount rail to one rear-mount rail (refer to Figure 6). Place three 8-32 x 0.375-inch Phillips truss head screws in the available holes. Leave the screws loose until step 8.

(3) SCREWS, 8-32 X 0.375 PHILLIPS TRUSS HEAD

Figure 6. Assembling a Support Rail

4.Repeat step 3 for the other rail set.

5.If installing the unit into a square-hole rack, insert 10 cage nuts into the square-hole rack (refer to Figure 7).

CAGE NUT

Figure 7. Inserting Cage Nuts

6.Attach one support rail assembly to the equipment rack in the desired location (refer to Figure 8 on page 14). NOTE: The support rail assemblies are identical and can be used on the right or left side of the rack.

a.Position the ear of the front-mount rail against the front of the equipment rack. Align the top and bottom holes in the ear of the rail with the threaded holes (or cage nuts) in the rack.

b.Using two 10-32 x 0.5-inch Phillips flat head screws, attach the ear of the rail to the front of the rack. Insert the screws from the outside of the rack, pointing towards the rear.

c.Adjust the rails to the correct depth of the equipment rack by sliding the rear-mount rail to the back of the equipment rack.

d.Position the ear of the rear-mount rail against the rear exterior of the equipment rack. Align the top and bottom holes in the ear of the rail with the threaded holes (or cage nuts) in the equipment rack.

C1695M-B (11/08) 13