Hardware Installation
EQUIPMENT PLACEMENT AND RACK MOUNTING
The DVR5100 can be placed on a flat surface, such as a desktop, or mounted in an equipment rack.
DESKTOP MOUNTING
WARNING: Do not place the DVR5100 unit on its side. In this position, the unit may fall over and cause equipment damage or personal injury.
To mount the DVR5100 on a desktop:
1.Ensure that the rubber feet are securely attached to the four corners of the bottom of the unit to prevent surface damage.
2.Position the unit to allow for cable and power cord clearance at the rear of the unit. Make sure that air flow around the unit is not obstructed.
RACK MOUNTING
The DVR5100 mounts into an
The rack must meet the following requirements:
•Rack standard:
•Rack column depth: 20 to 30 inches (50.8 to 76.2 cm).
•Column mounting hole provisions:
•Door systems (optional): Front doors must have at least 2 inches (5.1 cm) between the DVR5100 front bezel and the inside of the door. Rear doors may be used only on rack columns that are more than 26 inches (66.0 cm) deep.
WARNING: Slots and openings in the cabinet provide ventilation to prevent the unit from overheating. Do not block these openings. Never place the unit near or over a radiator or heat register. Provide proper ventilation when placing the unit in a
Figure 5 and Figure 6 on page 13 identify each piece of hardware for rack mounting.
To install the DVR5100 in a rack:
1.Attach one chassis mounting bracket to each side of the DVR5100. Use four
(4)SCREWS
PER BRACKET, 10.32 X
CHASSIS
BRACKET
RUBBER FEET
(4) SCREWS,
Figure 5. Chassis Brackets and Rubber Feet
2. Remove the four rubber feet from the underside of the unit. Save the rubber feet and screws for possible future use.
12 |