Pelco manual Mounting the DVR5100 into the Rack

e.Using two 10-32 x 0.75-inch Phillips pan head screws, attach the ear of the rail to the rear of the rack. Insert the screws from the outside of the rack, pointing towards the front.

RACK FRONT	RACK REAR
(4) SCREWS,	(4) SCREWS,
10-32 X 0.5-INCH	10-32 X 0.75-INCH
PHILLIPS FLAT HEAD	PHILLIPS PAN HEAD

FRONT-MOUNT RAIL REAR-MOUNT RAIL

Figure 8. Attaching Support Rails

7.Repeat step 6 for the second support rail assembly.

8.Tighten the 8-32 x 0.375-inch Phillips truss head screws that were attached to the front- and rear-mount rails in steps 3 and 4.

9.Place the unit onto the mount rails by sliding the chassis brackets onto the rails. This step may require two people to lift and slide the unit into place. The unit should slide in and out of the rack easily (refer to Figure 9).

WARNING: Do not allow the DVR5100 to fall when you are sliding the unit in or out of the rack.

Figure 9. Mounting the DVR5100 into the Rack

14 C1695M-B (11/08)