Elta 2322USB manual General Instructions, CD Playback

GENERAL INSTRUCTIONS

Turning on and off

Turn on/off: To avoid unnecessary power consumption, always set the function selector (8) to position TAPE (OFF) when not using the unit.

1.Use the function selector (8) to choose an operating mode: TAPE (OFF), CD/USB or TUNER.

2.Adjust the volume using the buttons + VOL UP (2) and - VOL DN. (3).

3.To turn off the unit, set the function selector (8) to position TAPE(OFF).

Electronic volume control

-The unit uses an electronic volume control.

-Press + VOL UP (2) or - VOL DN (3) on the unit to increase or reduce the volume.

-Release the button when you have reached your desired volume level.

Listening to the radio

Recommendations for a better reception:

-UKW (FM): The unit is equipped with a FM wire antenna (23) at the rear, which should be fully uncoiled. Direct the wire antenna for a better reception.

-MW (AM): The unit has a built-in AM antenna. Change the position of the unit when the reception is poor.

Radio reception

1.Set the function selector (8) to radio mode.

2.Use the band selector (18) to select a frequency range: AM, FM or FM ST.

The display shows the selected frequency range (FM or AM) and the current frequency (XXX.X MHz or XXX:X KHz).

3.Use the TUNING knob (10) to search a desired station.

4.To turn off the unit, set the function selector (8) to position CD/USB or TAPE (OFF).

NOTES:

•If a single FM (STEREO) station is poor and you hear a lot of background noise, set the band selector to FM (MONO). This way the reception often becomes better.

•The display shows (((FM ST))) when the band selector is set to FM ST. and a stereo station is played.

CD PLAYBACK

Insert/ take out a CD

Before you open the CD compartment, always make sure the CD is not spinning. Always press (17) on the unit or STOP/ on the remote control first.

-Insert a CD with the printed side facing up.

-After you have inserted the CD, carefully lower the CD door until it is completely closed.

-The CD is now ready for playback.

-To take out a CD, place one finger on the center of the CD (central shaft). Hold the CD with the other fingers on its edges and carefully lift it up.

-IMPORTANT: Always hold a CD on its edges. Protect the CD surface from finger prints, stains or dirt. Use a special CD cleaning cloth or cleaning kit to remove dirt or stains.

Normal CD playback (CD/MP3/USB)

1.Set the function selector (8) to position CD/USB. The POWER LED (4) lights up and the display shows DISC and no.

2.Press OPEN/CLOSE (11) to open the door of the CD drive on the top of the unit.

3.Insert a CD with the printed side facing up and close the door of the CD drive manually.

4.The display shows three dashes “- - -“ for a few seconds and subsequently the total number of tracks.

5.Press (7) on the unit or PLAY/PAUSE on the remote control to start playback of the first track.

19.