Eltax DR-110 Lpcm Setup, General Setup, Linear PCM OUT, Angle Mark, OSD Language

LPCM SETUP

This option sets the audio output format sent using the unit’s optical digital audio output.

Linear PCM OUT

LPCM 48K

In the Linear PCM setting, “48K” means “the digital audio output maximum sampling rate is 48kHz”; therefore, when the title’s encoding sampling rate* is 96kHz, the output will be forced converted to 48kHz.

LPCM 96K

If “96K” is selected, then the maximum output-sampling rate is 96kHz and no conversion will take place.

- - LPCM SETUP PAGE - -
LPCM OUTPUT	LPCM 48K
MAIN PAGE	LPCM 96K
SET LPCM OUTPUT TO 48 OR 96K

NOTES:

Sampling rate:

When a sound wave is converted to a digital signal, the sound is sampled and converted to data at a specific frequency rate. For example, a signal with a 96 kHz sampling rate indicates that in one second, the analog signal was sampled 96000 times to produce the digital signal.

In LPCM set-up menu, there will be a case that even when “LPCM 96K” is selected, output signal is converted to 48kHz if the disc has the copy guard management system in it.

DISC CODING AND OUTPUT FORMAT

Disc	Audio encoding format	Digital output format
	Dolby Digital®	Dolby Digital Bit stream
		(1~5.1 ch) or 48kHz/16bits
		2ch Linear PCM
	DTS®	Bit stream (1~5.1 ch) or OFF
DVD
	Linear PCM	Linear PCM
	(48/96kHz, 24bits)	(48kHz/16 bits up to 96kHz/24bits)
Video CD	MPEG 1	Linear PCM (44.1kHz sampling)
Audio CD	Linear PCM	Linear PCM (44.1kHz/16bit)

GENERAL SETUP

There are four available selections: ANGLE MARK, OSD LANG, CAPTIONS, and SCR SAVER.

ANGLE MARK

During playback of a title with multiple angle sections,

the message " " will appear on the upper corner of the screen.

When ANGLE MARK is set to "ON", the angle mark OSD will stay on the screen until the end of the playback title or chapter.

When ANGLE MARK is set to "OFF", the angle mark OSD will stay on the screen for 3 sec and then disappear.

- - GENERAL PAGE - -
ANGLE MARK	ON
OSD LANG	OFF
CAPTIONS
SCR SAVER
MAIN PAGE
ANGLE MARK ON/OFF

OSD LANGUAGE

You can select the language for the setup menu or the operation message display. There are five available OSD languages: ENGLISH, FRENCH, GERMAN, DUTCH and DANISH for display.

- - GENERAL PAGE - -
ANGLE MARK
OSD LANG	ENGLISH
CAPTIONS	FRENCH
SCR SAVER	GERMAN
	DUTCH
MAIN PAGE	DANISH
SET OSD LANGUAGE

19