BP7309 BANFF 1/5/06 9:59 AM Page 10
SW101 FAN/LIGHT WALL
CONTROL (SUPPLIED)
BLACK
TO (HOT)
120-
VOLT
SUPPLY
WHITE
GROUND
EMERSON
BLACK
BLACK
WHITE
WHITE
RED
CABLE (WITH
GROUND)
GREEN WIRE (GROUND)
FROM HANGER BALL AND
HANGER BRACKET
Figure 11
BLUE WHITE
BLACK
BLUE
WHITE
HANGER BALL
3. Push the wires and connectors up into the outlet box while inserting the receiver fully into the hanger bracket. Position the antenna wire on top of the receiver.
4. Screw the two
5. Lift the ceiling canopy up to the threaded studs and turn until the studs protrude through the holes in the ceiling canopy (Figure 12).
6. Secure the ceiling canopy in place by sliding lockwashers (supplied) over the threaded studs and installing the two knurled knobs (supplied) (Figure 12). Tighten the knurled knobs securely until the ceiling canopy fits snugly against the ceiling.
!WARNING
To avoid possible fire or shock, make sure that the electrical wires are completely inside the outlet box and not pinched between the ceiling canopy and the ceiling.
7. Using a wire connector (supplied), connect the black light fitter wire to the blue motor wire (Figure 13). Connect the white fitter wire to the white motor wire.
8. Remove and retain one of the three
M4 x 8mm oval head screws and lockwashers from the fitter adapter plate. Loosen the remaining two screws and lockwashers.
Figure 12
CEILING
CANOPY
| FITTER | |
| ADAPTER | |
| PLATE | |
| BLUE WIRE | |
| ||
THREADED |
| |
STUD (2) | BLACK WIRE | |
LOCKWASHER | ||
| ||
(2) | DOWNLIGHT | |
KNURLED | ||
KNOB (2) | FITTER ASSEMBLY |
Figure 13
REMOVE ONE M4 x 8mm
OVAL HEAD SCREW AND LOCKWASHER.
LOOSEN THE TWO REMAINING SCREWS AND LOCKWASHERS.
WHITE WIRES
KEYHOLE SLOTS
10