BP7309 BANFF 1/5/06 9:59 AM Page 4
k.One loose parts bag containing:
1.Two
2.Two knurled knobs
3.Two lockwashers
4.Three wire connectors
5.One clevis pin
6.One hairpin clip
7.Eleven M5 x 16mm oval head screws
8.Sixteen M5 x 6mm slotted Phillips washer head screws
AB 
C
Electrical Requirements
IMPORTANT: Your ceiling fan will not function properly, and may be damaged, if used with any wall dimmer switch or control other than the Emerson Electric SW101 Fan/Light Wall Control supplied with the fan, or an optional Emerson Electric SR100 Remote Control.
Your new ceiling fan will require a grounded electrical supply line of 120 volts AC, 60 Hz, 15 amp circuit.
The outlet box must be securely anchored and capable of withstanding a load of at least 50 pounds.
| D |
E | G |
| |
| F |
| I |
| H |
J
K
EMERSON
NOTE: Place the parts from the loose parts bags in a small container to keep them from being lost.
2.Remove the fan motor and housing uplight assembly from the protective plastic bag. Place the fan motor and housing uplight assembly on a padded work surface with the bottom of the motor facing up.
IMPORTANT: Remove the two card- board retainers from between the housing uplight and the motor housing.
!WARNING
To reduce the risk of fire, electric shock, or personal injury, mount fan to outlet box marked “Acceptable for Fan Support”, and use screws supplied with outlet box. Most outlet boxes commonly used for support of light fixtures are not acceptable for fan support and may need to be replaced. Consult a qualified electrician if in doubt.
If your fan is to replace an existing ceiling light fixture, turn electricity off at the main fuse or circuit breaker box at this time and remove the existing light fixture.
!WARNING
Turning off wall switch is not sufficient. To avoid possible electrical shock, be sure electricity is turned off at the main fuse or circuit breaker box before wiring. All wiring must be in accordance with National and Local codes and the ceiling fan must be properly grounded as a precaution against possible electrical shock.
4
