BP7309 BANFF 1/5/06 9:59 AM Page 7
CANDELABRA BULBS (4)
INSTALL THREE M4 x 12mm
PAN HEAD SCREWS AND
RUBBER WASHERS
UPPER
GLASS
MOTOR
AND
HOUSING
UPLIGHT
ASSEMBLY
11. The fan comes with blue, black and white leads that are 80” long. Before installing the fan, measure up approximately 6 to
12. You have now completed the initial assembly of your new ceiling fan. You can now proceed with hanging and wiring your fan.
How to Hang
Figure 5
Your Ceiling Fan
9. Screw in four
10. Place the ceiling canopy over the downrod. Then reinstall the hanger ball (Figure 6) on the downrod as follows. Route the three 80” motor leads through the hanger ball and slide the hanger ball over the downrod. Position the pin through the two holes in the downrod and align the hanger ball so the pin is captured in the groove in the top of the hanger ball. Pull the hanger ball up tight against the pin and securely tighten the setscrew in the hanger ball. A loose setscrew could create fan wobble.
PIN |
| |
HANGER | SETSCREW | |
BALL |
| |
CEILING | DOWNROD | |
CANOPY | ||
|
!WARNING
The fan must be hung with at least 7' of clearance from floor to blades (Figure 7).
CEILING
AT
LEAST
7'
FLOOR
Figure 7
!WARNING
The outlet box and joist must be securely mounted and capable of supporting at least 50 lbs. Use only a U.L. outlet box listed as “Acceptable for Fan Support”.
Figure 6 | 7 |
|