BP7309 BANFF 1/5/06 9:59 AM Page 5
Ceiling Fan Procedures M5 x 6mm SLOTTED PHILLIPS 
WASHER HEAD SCREWS (3)
General
Your Emerson ceiling fan comes supplied with a SW101 Fan/Light Wall Control and a Remote Control Receiver. This system allows you to regulate your ceiling fan speed and light intensity.
NOTE: An optional Emerson Electric SR100 Remote Control may also be used to control your ceiling fan.
How to Assemble Your Ceiling Fan
!WARNING
Turning off wall switch is not sufficient. To avoid possible electrical shock, be sure electricity is turned off at the main fuse or circuit breaker box before wiring. All wiring must be in accordance with National and Local codes and the ceiling fan must be properly grounded as a precaution against possible electrical shock.
IMPORTANT: Before assembling your ceiling fan, refer to the Owner’s Manual supplied with the SW101 Fan/Light Wall Control and set the operating frequency of the fan/light wall control and the Remote Control Receiver. Also, install the fan/light wall control in the wall box as described in the wall control Owner’s Manual. You are now ready to proceed with the assembly and installation of your ceiling fan.
1.Mount the fan blades to the blade flanges using three M5 x 6mm slotted Phillips washer head screws (Figure 1).
FAN
BLADE
BLADE FLANGE
Figure 1
2. Rotate the motor and housing uplight assembly so that one of the flange slots in the motor and housing uplight assembly lines up below the access cutout in the motor and housing uplight assembly (Figure 2). Insert the blade flange through the slot and line up the holes in the flange with the threaded holes in the motor and housing uplight assembly .
MOTOR AND
HOUSING
UPLIGHT
ASSEMBLY
ACCESS
CUTOUT
BLADE
FLANGE
FLANGE
SLOT
!WARNING
To reduce the risk of personal injury, do not bend the blade flange when installing the blade flanges, balancing the blades or cleaning the fan. Do not insert foreign objects in between rotating fan blades.
M5 x 16mm OVAL HEAD SCREWS (2)
Figure 2
!WARNING
To reduce the risk of personal injury, do not bend the blade flange when installing the blade flanges, balancing the blades or cleaning the fan. Do not insert foreign objects in between rotating fan blades.
5
