TROUBLE SHOOTING GUIDE
Symptom | Possibility causing/suggestion | |
|
| |
Indoor or outdoor temperature display shows up | If the indoor or outdoor temperature is below | |
“LL”. | This is not an error. | |
Indoor or outdoor temperature display shows up | If the indoor or outdoor temperature is over | |
“HH”. | 55 oC / 131 oF, “HH” shows. | This is not an error. |
Outdoor temperature display shows up “- - ”. | The code synchronization has been interrupted | |
| and needs to be redone. Please follow “To | |
| Synchronize Outdoor Temperature” steps 4 - 6. | |
Outdoor temperature display shows flashing | The Thermo Sensor is to far away from the main |
temperature. | unit; move it closer to the main unit until the |
| temperature reading stops flashing. |
| NOTES: |
| Placing the main unit near any electrical |
| appliance, i.e. Computer, TV, monitor, etc, may |
| cause a signal interference. Please |
| main unit. |
| Once the main unit has been relocated, it needs |
| to be resynced to the sensor. Please follow steps |
| 4 – 6 in the “To Synchronize Outdoor |
| Temperature” section of the manual. |
This “- - ” indicator is flashing on the outdoor | Main unit has started the code synchronization |
temperature display. | with the Thermo Sensor, please move the |
| Thermo Sensor closer to main unit until the |
| outdoor temperature display shows the |
| temperature. |
Transmitting indicator LED does not flash every 5 Check to see if the batteries have been inserted
seconds after installing the battery.correctly. Please follow the battery polarity (pg. 12) to install battery.
If the battery is inserted correctly and the LED is still not flashing, replace the battery.
16
