OTR (One Touch Recording)

This function enables you to set a recording length simply by pressing the REC/OTR button on the TV/DVD/VHS.

Make sure ...

TV/DVD/VHS power must be turned on.

Insert a cassette tape with its erase prevention tab in place. (If necessary, rewind or fast forward the tape to the point at which you want to begin recording.)

NOTES:

This function CANNOT be done from the remote control.

Recording starts immediately when the REC/OTR button is pressed.

When the REC/OTR button is pressed 18 times, the TV/DVD/VHS returns to the Normal Recording mode.

To stop the OTR operation, press the STOP button on the TV/DVD/VHS or on the remote control.

To show the remaining time, press the DISPLAY button on the remote control so that “OTR” appears on the TV screen. (It will show up momen- tarily then disappear.)

Recording stops when 0:00 is reached.

Please note that in the SLP mode maximum record- ing time, assuming the tape is started at the begin- ning, is 8 hours using T-160 (or 6 hours using T- 120).

If the tape runs out before the end time, the TV/DVD/VHS will switch to the Stop mode imme- diately, ejects the tape and turns itself off.

1Select the channel to be recorded

Press the number buttons on the remote control or the CHANNEL K or L button.

Remember: If the TV/DVD/VHS is connected to a cable box or satellite box, the TV/DVD/VHS must be on CH3 or CH4, then the channel to be recorded is selected on the cable box or satellite box.

2Select the tape speed

Press the SPEED button to select the desired tape speed (SP/ SLP).

3 Begin OTR

OTR(2 : 30)

Press the REC/OTR button on the TV/DVD/VHS as many times as needed. The recording length will

be determined by the number of SP

times you press the REC/OTR button. Each addition- al push will increase the recording time by 30 min- utes. It is set up to 8 hours.

Push(es)

Display

 

Recording length

1 push

 

(normal recording)

2 pushes

0:30

 

30 minutes

 

 

 

 

3 pushes

1:00

 

60 minutes

 

 

 

 

 

 

 

 

17 pushes

8:00

 

480 minutes

 

 

 

 

COPYING A VIDEO CASSETTE (Requires a VCR or camcorder)

You can make copies of video tapes made by friends or relatives for your enjoyment.

WARNING: Unauthorized recordings of copyrighted video tapes may be an infringement of copyright laws.

Connect your TV/DVD/VHS and a Source (Playing) VCR using the following diagram.

[The TV/DVD/VHS]

[Fig.8]

HEADPHONE VIDEO L-AUDIO-R

 

 

[Ex: Source (playing)

 

VCR or camcorder]

Audio/Video

AUDIO

 

L

 

 

adapter cable

OUT

IN

 

R

(not supplied)

VIDEO

 

 

 

OUT

IN

1)Insert a pre-recorded video cassette into the Source (Playing) VCR or camcorder.

2)Insert a blank video cassette, or one you want to record over, into the TV/DVD/VHS’s cassette com- partment.

3)Press the SPEED button on remote control for the TV/DVD/VHS to select the desired recording speed (SP/SLP).

4)Press the CHANNEL K or L button on the TV/DVD/VHS until “AUX” appears on the screen.

5)Press the RECORD button on the TV/DVD/VHS. 6)Begin playback of the tape in the source (Playing)

VCR or camcorder.

NOTE: For best results during copying, use the TV/DVD/VHS’s front panel controls whenever pos- sible. The remote control might affect the source (Playing) VCR’s playback operation.

- 31 -

EN

1C29

Page 31
Image 31
Emerson EWC19T1 owner manual Pushes Display Recording length, Push Normal recording, Minutes Pushes 800