
COMPONENTS IN THIS PACKAGE
START HERE PROPER INSTALLATION SHOULD TAKE ABOUT
|
|
|
|
| 3/8" Tube |
|
|
|
|
|
| Brass Nut / Ferrule / | |
|
|
|
|
| Tube Insert | |
Extension & Star Nut | 3/4" Screws (2) | Quick Connector |
| |||
| Washers |
|
|
|
| |
|
|
| ||||
|
|
|
|
| ||
Rubber | Small Steel | Large Steel | Fiber | Tank | ||
| Fitting (3 pieces) |
1 | PREPARATION | |||
A | Required minimum from | Maximum counter | ||
|
| center of hole to wall | thickness (depth) | |
| 25⁄8" | 3" | ||
| 25⁄8" | 3" | ||
| 25⁄8" | 3" | ||
| 23⁄8" | 3" | ||
| 11⁄4" | 3" | ||
| 2" | 3⁄4" | ||
|
|
|
|
|
■Identify locations for the dispenser faucet, tank and filter (if applicable).
■Check to make sure there is proper clearance (see chart at left) for dispenser handles to be fully opened.
■Check to make sure counter is not too thick (see chart at left).
■Make sure there is a grounded electrical outlet under the sink.
The wall outlet for your dispenser must have power supplied to it continuously and must be fused. It should not be controlled by the same wall switch
that operates your disposer, unless using an InSinkErator SinkTop SwitchTM.
Extension & Star Nut | 3/4" Screws (2) |
|
| |||
| Washers |
|
|
|
| |
|
|
| ||||
|
|
|
|
| ||
| Rubber | Small Steel | Large Steel | Fiber | Tank | |
| Fitting (3 pieces) |
3/4" Screws (2)
B
If you have to drill through sink or
countertop, you may need to rent or purchase
the appropriate tools.
■Turn off water supply.
■If using the sink sprayer hose hole, remove nut that connects sprayer hose at bottom of faucet.
■Using adjustable wrench, remove nut connecting sprayer washer flange in sprayer hole.
■Plug hose opening with either a 1/8" plug or a 1/4" cap (not supplied).
|
| Tank | ||
Mounting Plate | Wing Nut | Rubber Gasket Fitting (3 pieces) | ||
|
|
|
|
|
|
|
| 3/4" Screws (2) |
|
|
| Metal |
| |
Fiber Gasket | Mounting Plate | Mounting Screw Fitting (3 pieces) | Tank |
C
Required Hole Size
11⁄4" - 11⁄2"
Dependent on model
Consult a professional before drilling into
a surface other than stainless steel.
What if you don’t have a sprayer hole or don’t want to use it?
■Many homeowners replace the soap dispenser in their sink with an instant hot water dispenser.
■If drilling a hole into a stainless steel sink or counter top, you can cut a mounting hole for the dispenser with a hole saw for stainless steel, or you can use a hole punch.
4 | 5 |