FINAL WATER CONNECTION | ||
5 A Brass Nut |
| |
Ferrule | ■ Install a | |
cold water supply line. | ||
Brass Inser | ||
| ■ Install dedicated water control valve with | |
Plastic | 3/8" compression fitting. | |
■ At the end of the white 3/8" tube from the | ||
tube | ||
| ||
| nut and ferrule over the tube and then push | |
| in the brass tube insert. | |
Property Damage: Join remaining tube | ■ Insert the white 3/8" tube into the 3/8" | |
to cold water supply only. | compression fitting and tighten. | |
Electric Shock Hazard: Using an ungrounded or improperly connected appliance can result in serious injury or death from electrical shock.
This appliance must be grounded. This instant hot water dispenser is equipped with a cord that has a grounding conductor and a grounding pin. The plug must be connected to an appropriate outlet that is properly installed and grounded in accordance with all local codes and ordinances. Do not modify the plug provided with the appliance – if it will not fit the outlet, have a proper outlet installed by a qualified electrician. Check with a qualified electrician or serviceman if you are in doubt as to whether the instant hot water dispenser is properly grounded.
Personal Injury: This tank is a
DO NOT close vent tube or connect other type dispensers or valves to the tank. Use only the InSinkErator dispenser faucet supplied. Use only parts provided. Contact an authorized InSinkErator Service agent for repairs or replacement components.
A
Brass Nut
Ferrule
Copper tube
Property Damage: Join remaining tube
to cold water supply only.
H-View / H-Wave / H990 / H770
■Install a
■Install dedicated water control valve with 1/4" compression fitting (not included).
■At the end of the copper 1/4" tube, slide the brass nut and ferrule provided with the control valve over the tube.
■Insert the copper tube into the 1/4" compression fitting and tighten.
Fire Hazard: To minimize possibility of fire, DO NOT store flammable items such as rags, paper or aerosol cans near the tank. DO NOT store or use gasoline or other flammable vapors and liquids in the vicinity of this or any other appliance.
Property Damage: To avoid water damage, replace any loose or split tubing. Periodically inspect the unit for any signs of leakage and immediately remove from service any unit suspected of leaking.
An instant hot water dispenser, like any water heater, has a limited life and will eventually fail. To avoid possible property damage and personal injury, this instant hot water dispenser should be regularly examined for leakage and/or corrosion and replaced when necessary. A drain pan, plumbed to an appropriate drain or outfitted with a leak detector, should be used in those applications where any leakage could cause property damage. To check for corrosion, examine the appearance of the dispensed water in a clear glass once every three
FILL TANK & THEN CONNECT POWER | |
6 A | ■ Turn on the cold water supply. |
| ■ Depress the dispenser’s HOT |
| handle and hold it until water flows |
| from the spout (approximately 1 to |
| 2 minutes). |
| ■ Run the water for at least 2 minutes to |
Scalding Hazard: The faucet dispenses | flush lines (both the hot and cold |
(212ºF) water which can instantly cause scalds or | handles independently if applicable). |
burns. Use care when operating this appliance. |
|
(3)months. If there is any discoloration or rusty appearance, unplug and drain unit as described in the Seasonal Storage/Drainage section on page 12 of this manual. If the water discoloration remains after draining and refilling unit, discontinue use and contact an authorized InSinkErator service agent.
WARRANTY INFORMATION
Dispenser: |
|
Stainless Steel Tank: |
Covers all replacement parts and labor to correct defects in material or workmanship in the dispenser system, excluding the replaceable filter cartridge, for the full warranty period from the date of installation in your home. If warranty service is required during the warranty period, contact an authorized InSinkErator service agent to replace or repair the unit in your home at no cost to you. If your dispenser is replaced rather than repaired, the warranty on the new unit shall be for the duration of the remaining portion of the original dispenser’s warranty. Note:
B
Property Damage: A standard grounded outlet within 30" of the dispenser is required under the sink. Do not use an extension cord set with the dispenser.
■Check all connections to ensure they are tight and that there are no leaks.
■Plug in instant hot water tank.
Water will be cold at first.
Allow
Gurgling or hissing is normal during the initial heating cycle.
Warranty is determined by unit serial number and/or date of installation. Purchase or installation receipt may be required to verify warranty status. When service is required, and for the location of your nearest factory authorized service center, call toll free
The foregoing warranty does not apply to damage or inoperation resulting from accident, alteration, misuse, abuse, improper installation, installation not in accordance with these instructions or local electrical and/or plumbing codes. We do not assume any responsibility for consequential damage. Install using genuine InSinkErator® manufactured components only. Use of non InSinkErator components will void your warranty.
Some states do not allow limitations on how long an implied warranty lasts, or the exclusion or limitations of incidental or consequential damages, so the above limitations or exclusion may not apply to you. This warranty gives you specific legal rights, and you may also have other rights which vary from state to state.
10 | 11 |
