2 A

INSTALLING THE FAUCET - VIEW/ WAVE

View/Wave

 

Unpack dispenser components.

 

On a firm, flat surface, carefully

 

straighten the copper tubing using

 

hands only.

Property Damage: Do not pinch or break copper tubing. Do not distort the last 1 inch of tubing.

2 A

INSTALLING THE FAUCET - H990

H990

 

Unpack dispenser components.

 

On a firm, flat surface, carefully

 

straighten the copper tubing using

 

hands only.

Property Damage: Do not pinch or break copper tubing. Do not distort the last 1 inch of tubing.

B

158" Small

Steel Washer

158" Small

Rubber Washer

Standard 112" hole

158" Small

Steel Washer

158" Small Rubber Washer

214" Large

Steel Washer

Hole larger than 112"

View/Wave

For a standard 112" sink/counter hole

Feed tubes down through the hole in the sink/counter until the base is at rest. Set faucet at desired angle.

Large washer required for sink holes larger than 112" or for porcelain sinks with radius or beveled holes.

Before feeding tubes through sink

hole, remove extension. Place 214"

B

H990

Ensure that the black rubber gasket

is properly seated into the base of

the dispenser head and will

surround the sink mount.

Feed tubes down the hole in the

sink or countertop until the base is

Faucet is factory-ready for installation into a standard 112" sink/counter hole.

large steel washer over threads on

faucet base. Reinstall extension.

Make sure to use rubber gasket

to ensure proper seal.

at rest on the sink or countertop

surface.

C

Star Nut

Fiber

Washer

Hot & Cool models only

View/Wave

From under sink, slide 214" fiber washer over threaded extension. Thread star nut onto extension until snug.

Hot & Cool models only

Attach the quick connector to the ends

of the copper tubes running from the

dispenser.

C

H990

From under the sink, place the

semi-circular mounting plate onto the

threaded stud.

Place wing nut onto the threaded

stud. Make sure faucet head is at the

desired angle. Tighten the wing nut

An assistant may be needed to hold

the dispenser head in place while securing the dispenser.

Install a white 3/8" tube into other end

of quick connector.

An assistant may be needed to hold

the dispenser head in place while securing the dispenser.

until snug, while ensuring the semi-

circular mounting plate extends

beyond the sink hole.

158" Small

Steel Washer

158" Rubber

Washer

Figure 1

Fiber

Washer

Figure 2

Star Nut

Installing into hole smaller than 112"

Unscrew and remove threaded extension

from valve body. Do not discard, as you

will need this later (See Figure 1).

Leave small washers in place.

Feed tubes down through the hole in

the sink/counter until the base is at

rest. Set faucet at desired angle.

From under sink, slide 214" fiber washer

over faucet base. Reinstall threaded

If sink/counter thickness exceeds 3/4" a hole diameter of 112" is required.

extension onto the base until snug.

Thread star nut onto extension until

snug (See Figure 2).

6

7

Page 4
Image 4
Emerson h990 owner manual Installing the Faucet VIEW/ Wave, Installing the Faucet H990