Installing the Faucet H770, Mounting the Tank

2 A	INSTALLING THE FAUCET - H770
2 A	H770
	■ Unpack dispenser components.
	■ On a firm, flat surface, carefully
	straighten the copper tubing using
	hands only.

Property Damage: Do not pinch or break copper tubing. Do not distort the last 1 inch of tubing.

	MOUNTING THE TANK
	3 A	■ Select a spot under the sink to mount
	Tank must be	tank vertically within reach of both
	Tank must be	plumbing and electrical connections.
	mounted level	plumbing and electrical connections.
	mounted level	The tank should be within 16" or less
	to ensure	The tank should be within 16" or less
	to ensure	of faucet water lines and within 30"
	proper operation.	of faucet water lines and within 30"
	proper operation.	or less of a standard grounded outlet.
		or less of a standard grounded outlet.
		■ While holding tank in place on
	Property Damage: Tank must be located within 16" of	the spot selected for installation,
	Property Damage: Tank must be located within 16" of	use a pencil to mark locations for
	faucet and within 30" or less of a standard grounded	2 hanging screws.
	outlet. DO NOT extend plumbing or electrical lines.	2 hanging screws.

Fiber

Gasket

Make sure to use fiber gasket

■Ensure that the fiber gasket is properly seated against the base of the dispenser head.

DO NOT remove mounting screw or fiber gasket from base of dispenser.

allows clearance on the underside of the

tank for drainage, if necessary. DO NOT over tighten screws.

Screws provided are for use in wood studs or cabinets only. Use wall anchors (not supplied) for installation into drywall.

■Pre-drill 1/8" pilot holes at marks.

■Turn screws into pre-drilled holes, leaving 1/4" exposed.

■Hang the tank on the screws.

■Tighten the screws with only 1/2 turn clockwise.

the dispenser head in place while securing the dispenser.

H770

■Feed tubes down the hole in the sink or countertop until the base is at rest on the sink or countertop surface.

■Position faucet head at the desired angle.

CONNECTING FAUCET TO TANK
4 A			■ Without depressing the gray button,
(1)	(2)	(3)	place the snap-connect fitting at
(1)	(2)	(3)	the end of the blue 1/4" tube onto
			the left fitting on the tank, pushing
			until it clicks into place. (1)
			■ Slip the flexible white 7/16" tube
			over barbed middle fitting and slide
			down approximately 1/2". (2)
			■ Slip the clear 5/16" tube over the far

Half moon shaped metal mounting plate

should cradle all descending tubes.

H770

■From below the sink, place semi- circular metal mounting plate over the mounting screw, ensuring the mounting plate covers the sink hole.

■Slide washer over so that the screw is now inside the smaller hole. Tighten the screw until snug.

			right smooth fitting and slide down
			approximately 1/2". (3)
			approximately 1/2". (3)
			■ Visually check for pinched or
	Property Damage: Pinched or blocked water lines		■ Visually check for pinched or
	Property Damage: Pinched or blocked water lines		crimped tubes.
	may cause damage to the dispenser tank.		crimped tubes.
	may cause damage to the dispenser tank.
	Property Damage: Check to make sure		Hose clamps are not needed for any
	tubes are connected properly and are		of the connections.
	pushed down as far as possible.