Emerson SERIES 600T, Series 600 user manual 2VREG

Operation

Figure 59 READ ONLY level parameter view screen

>>	V_CHARGE SETPOINT	520	V
		500	V
>>	V_REG SETPOINT
		30.0
>>	MAX CHARGE CURRENT
			A/V
>>	CHARGE AMPS/VOLT	2.0
>>	V_REG_DELTA 1		A
		0	V
>>	V_REG_DELTA TRANSITION SOC
		0%
>>	V_REG_DELTA 2
		0	V
HELP		DONE

In the USER mode, below the 7 basic parameters can be modified, see 6.3.2 - Password for access level and passwords. Pressing the corresponding number to the parameter to the left of the number will take you to the parameter setup screen for that particular parameter.

Figure 60 USER level or above parameter edit screen

1.	V_CHARGE SETPOINT	520	V
2.	V_REG SETPOINT	500	V
3.	MAX CHARGE CURRENT	30.0
4.	CHARGE AMPS/VOLT	2.0	A/V
5.	V_REG_DELTA 1	0	V
6.	V_REG_DELTA TRANSITION SOC	0 %
7.	V_REG_DELTA 2	0	V
HELP			DONE

In setting the parameters there is a help screen to guide the user through the setup and help visualize the operation the system when utilizing this parameter. The help screens are displayed in Figures 61 and 62. The help screen also describes the other system parameters used in operation.

Figure 61 HELP screen for User Setup Parameters

When voltage is above [1] V_CHARGE

Flywheel charges up and draws :

(( Vbus – [1] V_CHARGE) * [4]		AMPS/VOLT) amps,
Not exceeding [3] MAX CHARGE CURRENT.
When voltage sags, it is regulated at
[2]	V_REG whose slope can be adjusted by
[5]	DELTA 1, [6] SOC TRANS, &	[7] DELTA 2
MORE		DONE
		DONE

Figure 62 Graphical HELP screen for VREG DELTA1, VREG TSOC, and VREG DELTA2 Transition setup

(Pressing the “MORE” button, F1, from Figure 5-8. accesses this screen)

-------------------------[2]V_REG******
			******		[5]DELTA1
		V	******-------------
		O	**		[6]DELTA2
		L
				**---------
		T
+----	+
			PREV			DONE
	100%	[7]TSOC 0%

60