Emerson Process Management ES30 owner manual Operating Instructions, Turning The System ‘On’

Models: ES30

1 44
Download 44 pages 21.72 Kb
Page 14
Image 14
OPERATING INSTRUCTIONS

OPERATING INSTRUCTIONS

Make sure that the speakers are properly connected.

Make sure that the FM Wire Antenna is fully extended.

Make sure that you have installed batteries in the remote control.

Make sure that the AC power cord is connected to an outlet that is always “live”. Do not connect to an outlet that is controlled by a wall switch.

Turning The System ‘On’

Connect the unit into the 120V 60Hz AC outlet.

At the front of the unit, the light within the POWER/STANDBY Turning The System ‘On’ button will light ‘Red’to indicate that the unit is in standby (Standby means plugged-in but not switched on).

Switch the unit ‘On’by pressing the POWER/STANDBY Manual background button on the front panel or the remote control. The “Red” light goes ‘Off’.

The unit is now ready to use.

13

ES30_072905.p65

13

29/7/2005, 16:41

Page 14
Image 14
Emerson Process Management ES30 owner manual Operating Instructions, Turning The System ‘On’