EMI EMI Corp Start-Upand Troubleshooting Test Procedure, Test Unit Performance Data, Power Input

START-UP AND TROUBLESHOOTING TEST PROCEDURE

The Test Unit Performance Data sheet below is provided for use by a qualified service professional. In order for our Techni- cal Service Department to better serve you, please complete and have this information

ready when calling. Make sure to include the Model Number, Serial Number, Date of Installation.

Call our Technical Support Department

@ 1-800-228-9364.

Test Unit Performance Data

Model Number

Serial Number

Indoor Section

Evaporator Entering Air - DB

Evaporator Entering Air - WB

Evaporator Leaving Air - DB

Evaporator Leaving Air - WB

Outdoor Section

Entering Air

Leaving Air

Temperature Split

Operating Pressures

Compressor Suction - PSIG

Compressor Discharge - PSIG

Power Input

Compressor - Volts

Compressor - Amps

OD Fan Motor - Volts

OD Fan Motor - Amps

ID Fan Motor - Volts

ID Fan Motor - Amps

Total Volts

Total Amps

Temperatures - Degrees F°

Compressor Suction

Compressor Discharge

Liquid Out Cond.

Liquid before Expansion

Suction out Evaporator

Capacity Calculations

DB - Temp Split at evap.

Date:

Technician:

Mode: Cooling

Notes

Note: Rotary compressors are critically charged sys- tems, do not over charge. Refer to the Charge Table specific to the unit being installed or call the factory. Anti-short cycle protection should be used on systems that use a conventional thermostat.

Test Summary

Compressor Superheat

Sub Cooling

Save this information for future servicing. In the event there is a problem with the unit. Perform the test again (if possible) and have both sets of data ready when calling for assistance.

Multi-zone Heat Pump Condensing Units 15 www.enviromaster.com