General Glass Information
Only glass approved for use in Empire Comfort Systems, Inc. fireplaces may be used for replacement. The glass replacement should be done by a licensed or qualified service person.
WARNING:
1.The use of substitute glass will void all product warranties.
2.Care must be taken to avoid breakage of the glass.
3.Under no circumstances should this appliance be operated without the glass front or with a broken glass front. Replacement of the glass (with gasket) as supplied by the manufacturer should be done by a qualified service person.
4.Do not abuse the glass by striking or hitting the glass.
WARNING: Do not use abrasive cleaners on glass. Do not attempt to clean glass when glass is hot.
Failure to follow these warnings could cause a serious safety issue to the operator, such as fire or other serious conditions.
A replacement glazing/frame assembly shall be replaced as a complete unit as supplied by Empire Comfort Systems, Inc.
Figure 19
Installation of Logs (Figure 19 and Figure 20 )
1.Lower valve cover on firebox.
2.Release two door latches at bottom of firebox.
3.Grasp bottom of glass frame, pull forward until bottom of glass frame is removed from glass frame guide and pull downward until glass frame is removed from glass frame support top.
4.Remove logs from interior of firebox. Remove all protective packaging from logs and interior of firebox.
5.Align the two rear pins on the base with the two alignment holes on the underside of the rear log. Place the rear log onto the two rear pins on the base.
6.Align the two front pins on the base with the two alignment holes on the underside of the front log. Place the front log onto the two front pins on the base.
7.Align the two alignment holes on the underside of the top log with the alignment pins on the top of front log. Place the top log onto the two pins on the front log.
8.Grasp bottom of glass frame, push upward and insert glass frame into glass frame support top, push inward and insert glass frame into glass frame guide.
9.Attach two door latches to bottom of firebox.
10.Installation of logs is completed.
Warning: Failure to position the parts in accordance with this diagram or failure to use only parts specifically approved with this appliance may result in property damage or personal injury.
Avertissement: Risque de dommages ou de blessures si les pièces ne sont pas installées conformément à ce schéma et ou si de pièces autres que celles spécifiquement approuvées avec cet appareil sont utilisées.
Figure 20
Replacement of Gasket on Glass Frame Assembly and Front Flange on Inner Body
1.Remove casing top from outer casing.
2.Remove casing front from outer casing.
3.Lower valve cover on firebox.
4.Release two door latches at bottom of firebox.
5.Grasp bottom of glass frame, pull forward until bottom of glass frame is removed from glass frame guide and pull downward until glass frame is removed from glass frame support top.
6.Place glass frame assembly on a
7.Remove the (6) screws and (6) nuts on the glass frame assembly.
8.Remove the (2) 1" x
9.Remove the gasket that is to be replaced on the glass frame and front flange on inner body. Clean the glass frame and front flange on inner body before the new gasket is attached.
10.Remove the backing material from the gasket.
11.Place the gasket around each opening in the glass frame and around the front flange on inner body.
Page 13
