Empire Comfort Systems CIBV-30-2 installation instructions This is a Heating Appliance

Introduction

Always consult your local Building Department regarding regulations, codes or ordinances which apply to the installation of a vented fireplace heater.

Instructions to Installer

1.Installer must leave instruction manual with owner after installation.

2.Installer must have owner fill out and mail warranty card supplied with heater.

3.Installer should show owner how to start and operate heater and thermostat.

WARNING:Any change to this fireplace heater or its controls can be dangerous. Any safety screen or guard removed for servicing a fireplace heater must be replaced prior to operating the fireplace heater.

General Information

This appliance is design certified in accordance with American National Standard /Canadian Gas Association Standard ANSI Z21.88-1998 and CSA 2.33-M98 by the American Gas Association and Canadian Gas Association, as a Vented Fireplace Heater and must be installed according to these instructions.

Any alteration of the original design, installed other than as shown in these instructions or use with a type of gas not shown on the rating plate is the responsibility of the person and company making the change.

Important

All correspondence should refer to complete Model No., Serial No. and type of gas.

Notice: During initial firing of this unit, its paint will bake out and smoke will occur. To prevent triggering of smoke alarms, ventilate the room in which the unit is installed.

Installation on Rugs and Tile

If this appliance is to be installed directly on carpeting, tile, or other combustible material, other than wood flooring, the appliance shall be installed on a metal or wood panel extending the full width and depth of the appliance.

The base referred to above does not mean the fire-proof base as used on wood stoves. The protection is primarily for rugs that may be extremely thick and light-color tile that can discolor.

WARNING: If not installed, operated and maintained in accor- dance with the manufacturer's instructions, this product could expose you to substances in fuel or from fuel combustion which can cause death or serious illness.

Specifications

Model		CIBV-30
Input BTU/HR (KW/H) Max. (LP/NAT)		30,000 (8.7)
BTU/HR (KW/H) Min. (LP)		22,000 (6.4)
BTU/HR (KW/H) Min. (NAT)		19,500 (5.7)
Height		27 3/4" (8.7cm)
Width		25 1/2" (64.8cm)
Depth including diverter		21" (53.3cm)
Gas Inlet		1/2" (13mm)
Size Draft Diverter Collar		4" (10.16cm)
Floor to top of collar on vertical
position of Draft Diverter		27 3/8" (69.5cm)
Floor to center of collar on horizontal
position of Draft Diverter		23 1/2" (59.7cm)
Stove Casting (Must be ordered with Firebox.)
CIFB-1	Flat Black
CIPB-1	Porcelain Black
CIPG-1	Porcelain Green
CIPS-1	Porcelain Sand
CIPN-1	Porcelain Navy
CIPR-1	Porcelain Red
Accessories
GWSG-T	750 Millivolt Thermostat
FRBC-1	Battery Operated Remote Control
FRBTC-1	Battery Operated Remote Control
	with Thermostat
FREC-1	Electric Remote Control
FWS-1	Wall Switch
CIB-2	Automatic Blower
Stone Inlay Replaces Standard Grille Top
CII-2	Stone Inlay	Empress Green
CII-3	Stone Inlay	Hunan Jade
CII-4	Stone Inlay	Gray Botticino
CII-5	Stone Inlay	Azul
CII-6	Stone Inlay	Salome
CII-7	Stone Inlay	Black Swan

WARNING: Do not operate appliance with the glass front re- moved, cracked or broken. Replacement of the glass should be done by a licensed or qualified service person.

THIS IS A HEATING APPLIANCE

DO NOT OPERATE THIS APPLIANCE WITHOUT FRONT PANEL INSTALLED.

• Due to high temperatures, the fireplace heater should be located	• S'assurer que le brûleur et le compartiment des commandes sont
out of traffic and away from furniture and draperies.		propres. Voir les instructions d'installation et d'utilisation qui
• Children and adults should be alerted to the hazards of high		accompagnent l'appareil.
surface temperature and should stay away to avoid burns or	•	DO keep the appliance area clear and free from combustible
clothing ignition.		material, gasoline and other flammable vapors and liquids.
• Young children should be carefully supervised when they are in	• DO examine burners periodically. Clean and replace damaged
the same room as the fireplace heater.		parts.
• Clothing or other flammable material should not be placed on or	• CAUTION: The glass used in your heater is a special high
near the fireplace heater.		temperature ceramic glass. If the glass is cracked or damaged
• Surveiller les enfants. Garder les vêtements, les meubles, l'essence		in any way, it should be replaced only with a complete glass
ou autres liquides à vapeur inflammables lin de l'appareil.		frame assembly from Empire. See parts list on Page 18 for
• Due to high surface temperatures, keep children, clothing and		ordering.
furniture away.	•	DO NOT use this heater if any part has been under water.
• The glass front or any part removed for servicing the appliance		Immediately call a qualified service technician to inspect the
must be replaced prior to operating the appliance. Work		heater and to replace any part of the control system and any gas
should be done by a qualified service person.		control which has been under water.
• Keep burner and control compartment clean.	•	Ne pas se servir de cet appareil s'il a été plongé dans l'eau,
• Installation and repair should be done by a QUALIFIED SER-		complètement ou en partie. Appeler un technicien qualifié pour
VICE PERSON. The fireplace heater should be inspected before		inspecter l'appareil et remplacer toute partie du système de
use and at least annually by a qualified service person. More		contrôle et toute commande qui ont été plongés dans l'eau.
frequent cleaning may be required due to excessive lint from	• Under no circumstances should any solid fuels (wood, coal,
carpeting, bedding material, etc. It is imperative that control		paper or cardboard etc.) be used in this appliance.
compartments, burners and circulating air passageways of the
fireplace heater be kept clean.

Page 2 R-3450