INTERMITTENT PILOT LIGHTING INSTURCTIONS
FOR YOUR SAFETY, READ BEFORE LIGHTING 
WARNING: If you do not follow these instructions exactly, a fire or explosion may result causing property
damage, personal injury or loss of life.
A. This appliance is equipped with an ignition device which automatically lights the pilot. Do not try to light the pilot by hand.
B.Before lighting smell all around the appliance area for gas. Be sure to smell next to the floor because some gas is heavier than air and will settle on the floor.
What To Do If You Smell Gas
•Do not try to light any appliance.
•Do not touch any electrical switch;
•Do not use any phone in your building.
•Immediately call your gas supplier from a neighbor's phone. Follow the gas supplier's instructions.
•If you cannot reach your gas supplier, call the fire depart- ment.
C.Use only your hand to push in or turn the gas control knob. Never use tools. If the knob will not push in or turn by hand, don't try to repair it; call a qualified service technician. Force or attempted repair may result in a fire or explosion.
D.Do not use this appliance if any part has been under water. Immediately call a qualified service technician to inspect the appliance and to replace any part of the control system and any gas control which has been under water.
LIGHTING INSTRUCTIONS
1.Stop! Read the safety information above. 2.Set the thermostat to lowest setting. 3.Turn off all electric power to the appliance.
4.This appliance is equipped with an ignition device which automatically lights the pilot. Do not try to light the pilot by hand.
GAS CONTROL KNOB
SHOWN IN "OFF” POSITION.
OFF
ON
HONEYWELL
5.Lower louver front assembly.
6. Turn gas control knob clockwise 
to "OFF."
7.Wait ten (10) minutes to clear out any gas. Then smell for gas, including near the floor. If you smell gas, STOP! Follow "B" in the safety information above. If you don't smell gas, go to the next step.
8.Turn gas control knob counterclockwise 
to "ON".
9.Close louver front assembly.
10.Turn on all electric power to the appliance.
11.Set thermostat to desired setting.
12.If the appliance will not operate, follow the instructions "TO TURN OFF GAS TO APPLIANCE" and call your service technician or gas supplier.
TO TURN OFF GAS TO APPLIANCE
1.Set the thermostat to lowest setting. (if applicable.)
2.Turn off all electric power to the appliance if service is to be performed.
3.Open bottom louver assembly.
4.Turn gas control knob clockwise
to "OFF". Do not force.
5.Close bottom louver assembly.
Page 36 |
