OPTIONAL FRESH AIR KIT INSTALLATION INSTRUCTIONS
FOR DELUXE AND PREMIUM FIREBOXES
The optional BVA1 Fresh Air Kit is designed to introduce outside air to the fireplace or firebox as desired.
It must be installed prior to, or at the time of fireplace or firebox installation to framing.
The Fresh Air kit must be installed prior to the installation of wall- board or other finishing materials around the unit.
Tools needed: Gloves, Metal snips,
| Standard Screwdriver |
Caution: | Sharp edges |
Air Door Installation for Vent Free Firebox Models: VFD(32,36,42)FB
1.Begin by removing the rectangular cutout located on the left side of the firebox. Use gloves and sheet metal snips to cre- ate the opening for the Air Door assembly to install into. See
Figures 13 and 14.
Figure 15
4.Next, with the vise grip attached, feed the long control rod through the small rectangular opening at the left side of the firebox face. Carefully position the rod and bracket so that the bracket can be secured to the inside opening of the firebox with two screws. See Figure 16. Do not remove vise grips at this time.
Figure 13
Figure 16
5.Working from the side cutout opening, place the slightly opened air door assembly into the cutout opening as shown in Figure 17.
TO INSTALL
REMOVE RECTANGULAR
SHEET METAL CUTTERS
Figure 14
2.Move the left hand curtain screen to the center of the firebox opening.
3.Grasp the long control rod lever with control bracket (items 7 and 8 in Fresh Air Kit Parts List) securely with a vise grips as shown in Figure 15.
Figure 17
6.While holding the door assembly in your left hand, grasp the vise grip (attached to the long control rod). Rotate and move the control rod around until the inside end of the rod is mated
Page 9 |
