FIREBOX INSTALLATION INSTRUCTIONS (continued)
Locating Firebox
Place firebox in framing opening. Use the four (4) framing brackets provided on the firebox to attach firebox to framing. Different hole locations can be used for finishing materials with thicknesses of 3/8", 1/2" and 3/4". Attach these materials with screws provided, two (2) per framing bracket. See Figure 8.
Framing brackets should fit directly against framing material. Use at least one (1) nail per bracket to secure in place.
Check squareness of the firebox prior to securing to framed opening.
See Figure 9.
FIREBOX OPENING
ATTACH (4) FRAMING BRACKETS TO SIDES OF FIREBOX PRIOR TO INSTALLING
UNIT TO FRAMED OPENING
Figure 8
CHECK TO SEE
THAT BOX IS SQUARE
PRIOR TO ATTACHING TO
FRAMING 
Figure 9
INSTALLING HOOD
A black hood that is furnished with each firebox (or optional hood) MUST be installed before the firebox is used. Failure to do so may create a possible fire hazard. The hood is located behind upper louver, or inside the firebox on flush face units. If brass, stainless steel, or hammered pewter hoods are desired, they can be purchased as an option. Attachment is the same as the standard black hood.
Flush Face Models
1.On flush face models, loosen the two screws (A) holding firebox top to face panel, then slide the hood flange between the firebox top and face panel and
2.Install one (1) screw at each end of the hood as shown (C).
Louvered Models
1.If you have a louvered model, remove upper louver.
2.Place the top hood flange on top of the firebox, then install three screws through the firebox top from below and screw into the pilot holes in the hood flange (B).
3.Install one (1) screw at each end of the hood as shown (C).
4.
Caution: The hood must be installed prior to operation of appliance.
See Figure 10
Flush Face Models
A
C A C
Louvered Models
C
B
C 
B B
Figure 10
Page 7 |
