EnGenius Technologies 1X Receiving a Telephone Call, Adjusting Receiver Earpiece Voice Volume

[Note] Intercom numbers (Handset ID) are not stored in the last 10 numbers dialed log.

To end a telephone or intercom call, press END key or place handset into charger cradle.

Receiving a Telephone Call

1.	When an incoming call arrives, the ringer will ring or vibrate unless the
	ringer has been turned off.
2.	If the handset is on the charger cradle (ringer will be temporarily
	switched to “Ring” if it has been set to “Vibrate”), lift the handset and

Adjusting Receiver (Earpiece) Voice Volume

1.Voice volume can only be adjusted during a call.

2.There are 6 levels of volume selections. Default as volume 4. Use ¿andÀ scrolling key to adjust.

­ 11

00:00:10

Volume:4

OPTION HOLD

start conversation.

3. The new setting remains effective for all future calls until changed.

3. If the handset is not on the cradle, press any key (except END, and the

Silent soft key) to answer.

Notes:

1.	You can press			SILENT	(Left) soft key if you choose to ignore
	the call. Unlike			turning	off the ringer (from the handset menu),
	the	SILENT	key operation is valid only for the current call.
2.	If Caller ID		service is available, the LCD will display the

Placing a Call On Hold

1.When a call is in progress, it can be put on hold by pressing the HOLD (Right) soft key.

2.To return to the conversation, press “UNHOLD”

­ 11

You have a Call on hold

UNHOLD OPTION

incoming call information. If the LCD shows “Private” or

“Unknown”, the caller’s information may have been blocked by

the caller or the originating phone company.

Receiving an Intercom Call

1.When an intercom call arrives, the ringer will ring or vibrate unless the ringer has been turned off. Press TALK to answer the intercom call.

2.If the handset is on the charger cradle (ringer will be temporarily switched to “Ring” if it has been set to “Vibrate”), lift the handset and start conversation.

3.If the handset is not on the cradle, press any key (except PWR, END, and the SILENT soft key) to answer.

Notes:

1.The LCD displays the caller’s Handset ID.

2.You can press the SILENT if you choose to ignore the call. Unlike turning off the ringer the SILENT key operation is valid only for the current call.

Ending a Call

Notes:

1.The call being placed on hold can only be “un-hold” by the handset that puts it on hold.

2.Handset LCD displays a call is being on hold. An alert tone (double beep) every 30 seconds will remind the handset that a call is being on hold.

3.If the operation (e.g., call transfer) after putting a call on-hold fails, the held call may be dropped.

4.You can power off the handset (e.g., change battery) while call is on hold. After power on again, you can continue the call by pressing UNHOLD (Left) soft key or select “3” from the Option menu to terminate the hold state.

5.You can only unhold the call with the base coverage. Once you’re out of the base coverage, you can return to stand-by using “Clear hold” function in the OPTION list item #3.

Mute

1.After a link is established, you can press OPTION (Left) soft key and press “0” to mute the handset microphone.

2.When mute is active, the other end will not hear your voice, but still can speak to you.

3.To leave the mute state, press “UNMUTE” (Left) soft key. Mute is

~27~ ~28~