packets are transmitted without encryption. Shared Key sends an unencrypted challenge
text string to any device attempting to communicate with the AP. The device requesting
authentication encrypts the challenge text and sends it back to the access point. If the
challenge text is encrypted correctly, the access point allows the requesting device to
authenticate. It is recommended to select Auto if you are not sure which authentication
type is used.
• Key Length: Select a 64-bit or 128-bit WEP key length from the drop-down list.
• Key Type: Select a key type from the drop-down list. 128-bit encryption requires a longer
key than 64-bit encryption. Keys are defined by entering in a string in HEX (hexadecimal -
using characters 0-9, A-F) or ASCII (American Standard Code for Information Interchange
- alphanumeric characters) format. ASCII format is provided so you can enter a string that
is easier to remember.
• Default Key: You may choose one of your 4 different WEP keys from below.
• Encryption Key 1-4: You may enter four different WEP keys.
• Enable 802.1x Authentication: Place a check in this box if you would like to use RADIUS
authentication. This option works with a RADIUS Server to authenticate wireless clients.
Wireless clients should have established the necessary credentials before attempting to
authenticate to the Server through this Gateway. Furthermore, it may be necessary to
configure the RADIUS Server to allow this Gateway to authenticate users. You will then be
required to specify the RADIUS Server’s IP address, port, and password.
Encryption: WPA pre-shared key
• ESSID Selection: As this device supports multiple SSIDs, it is possible to configure a
different security mode for each SSID (profile). Select an SSID from the drop-down list.